This really handy stainless adaptor ball valve will enable you to connect two PCO 1881 threads with a valve in between. Each side has an integrated O-ring that will seal on the neck of the PCO1881 Thread. Ideally suited to making a dry hop device for FermZilla.

These robust stainless steel fonts will last forever and will not corrode like many other chrome plated steel fonts.

The brushed stainless finish looks great and also suits the brushed finished on many kegrators including the Series 4 Kegerator that we sell.

These fonts are also insulated with closed cell insulation foam inside the font so it fits snugly preventing heat ingress into your beer.

These fonts are perfect for air cooling and can be used with a Font Fan Kit 

Specifications:
- 320mm Tall (without taps)
- 78mm Diameter
- Base Collar Diameter 111mm
- Internal Foam Insulation

Note: does not include taps

These robust stainless steel fonts will last forever and will not corrode like many other chrome plated steel fonts.

The brushed stainless finish looks great and also suits the brushed finished on many kegrators including the Series X Kegerator that we stock.

This unit has been designed to fit our standard Quadruple Tap Kegerator Tower or any other 115mm diameter font. It does not fit 1-3 tap kegerator towers.

Keep your beer icy-cold with this insulated tower/font cover right out of the first drop. Most kegerators that we sell include a font fan that blows cold fridge air up the font. With that said heat loss from the stainless font surface causes the font temperature to rise meaning that a small amount of beer contributes to the "first pour foam effect".

This jacket is designed to insulate your FermZilla 27L fermenter during the colder months to keep your fermentation at the optimum temperature.

It can also be used with a heater belt to warm up the wort if the heat from the fermentation isn't enough.

Completely blocks any light/UV to prevent light-stuck beer.

From: Kegland

Stainless steel elbow Tail Piece for your beer shank.

From: Krome Dispense
Material: 304 grade stainless steel

You may also need a hex nut or wing nut, and neoprene washer.

Our standard bench capper provides an easy way to cap your beer bottles.

It is made from steel and with rubber grip pad so your bottles don't slip off the platform

This bottle capper can be used on different size bottles as the hight of the bell can be adjusted, and it can be bolted to sturdy surface.

Features:
- Easy to use and adjust to required heights depending on bottle size
- Comes with a standard bell which has a built in magnet to hold the bottle cap
- Simply place bottle caps in the bell then place the bottle underneath and pull the handle down

The capper is shipped flat-packed and needs assembling before use.