1. Stick-on Thermometer strip
    $6.50

    Stick-on Thermometer strip

    Stick-on Thermometer strip graded from 10 degrees C to 40 degrees C. Can be stuck to the outside of any fermenter to give an indication of the temperature of the liquid inside.

    We find these are quite reliable but it is always a good idea to test the calibration of any thermometer from time to time. For these stick-on versions, we recommend doing this especially as it gets older or if it is exposed to excessive heat such as hot cleaning water.
  2. Poly bulkhead for 6.5mm diameter temperature probe
    $19.90

    Poly bulkhead for 6.5mm diameter temperature probe

    Poly bulkhead for 6.5mm diameter temperature probe
  3. Dial thermometer with 42mm probe and weldless Kit
    $35.00

    Dial thermometer with 42mm probe and weldless Kit

    A bi-metal weldless thermometer with 3" stainless steel housing, hermetically sealed in a water proof case with glass face. Ideal for fitting to your mash tun, hot liquor tank or kettle. Provides temperature readout in both Fahrenheit and Celsius. The thermometer kit include 1 x stainless washer, 1 x 1/2"NPT/BSP Lock Nut, 2 x Silicone O-rings. Requires a 7/8" drill bit to install. To prevent leaking, wrap the 1/2" BSP threads with Teflon tape prior to threading into the port.
  4. Thermometer Stick On - Large
    $8.90

    Thermometer Stick On - Large

    Ideal for the outside of fermenter barrels, these stick-on thermometer strips cover a temperature range from 2 degrees to 25 degrees (or 36F to 78F). Includes markings for ideal lager and ale fermentation temperatures.
  5. Thermometer - 150mm Thermometer - 150mm
    $7.20

    Thermometer - 150mm

    Reads 0 -100 Contains no mercury For use with the Euro 5 and MK5E stills
  6. Clip-on pot thermometer Clip-on pot thermometer
    $15.00

    Clip-on pot thermometer

    Stainless steel thermometer with attachment clip to go on the side of a pot. Perfect for partial extract brewing.
  7. pH 9.18 Buffer Solution Powder for pH Meter
    $1.00

    pH 9.18 Buffer Solution Powder for pH Meter

    pH Buffer powder 9.18 to use for calibration of pH meters. Designed to be used with R.O water at 25 degrees celcius. Add contents to 250ml of water until dissolved.
  8. Plastic Jug - 3L Plastic Jug - 3L
    $13.90

    Plastic Jug - 3L

    Sometimes a 1L jug is too small and a 5L jug is too big. For these occasions, often a 3L jug is just what you need. This one comes with a sturdy handle and a graded scale on the side so you can use it to measure out smaller quantities too.
  9. Glass trial jar - 100ml
    $15.30

    Glass trial jar - 100ml

    Glass trial jar - 100ml. Suitable for hydrometer readings.

    Has a graded scale allowing you to measure volumes of liquid from 10ml to 100ml in 1ml increments. The main tube is approximately 21.8cm deep, and it has a lipped edge to assist with pouring liquids out. Diameter of the base is approximately 5.5cm.
  10. Hydrometer, 3 scale
    $12.80

    Hydrometer, 3 scale

    A brewing hydrometer is a very useful tool for any kind of fermentation. By tracking starting gravity and finishing gravity, you will be able to establish the level of alcohol that has been produced. This is also very helpful when trying to identify if fermentation is complete, which is very important to establish before bottling if you wish to avoid bottle-bombs.

    This hydrometer is ideal for wine-making, beer-brewing and cider-making. It includes three scales, allowing you to read specific gravity, potential alcohol, and grams per litre of sugar.