A carbonation or aeration diffusion stone. This can be used as a way to aerate your wort prior to fermentation, or to speed up carbonation of the finished beer.

The barb fits 1/4" (6.35mm) ID tubing.

The Kegerator Cover is an ideal solution for storing your Kegerator outside or exposed to water/dust or dirt. Keep your Kegerator in the best condition you can. 

Suitable for all Kegmaster Series 4 tap configurations.

Features: 
- Hot tape sealed stitching 
- Waterproof fabric 
- Side panels for easier door access (no need to take the entire cover off to open the door, just open the side panel)

This Hop Tube is made from 304 stainless steel and is ideal for addling larger amounts of hop pellets, flowers or spices to your RoboBrew / BrewZilla without blocking the pump. It can also be used in your Brewhouse Kettle/Boiler, 19L corny keg, and the FermZilla. It cannot fit in a standard 50L Keg as the opening is not wide enough. The fine mesh will prevent large particles from blocking the dip tube, pumps or chillers. It will hold approximately 150g of hop pellets, allowing for some space to permit full extraction of the hop oils. Ideal for dry hopping in the keg and can also be used for fruits, wood chips, spices and more. Includes a small ring so it can be hung from the keg lid or side of the vessel. 

Diameter: approx. 66mm Heigh: approx. 300 mm.

Easily fill your jugs, growlers or bottles from your keg dispensing beer tap. The Filler extends your tap and allows you to transfer the beer via the bottom of the vessel to help reduce the loss of CO2 and limit foam. The double o-ring design ensures a very snug fit inside the faucet.

Compatible with Krome and most standard taps except the Edge tap, Nukatap, Intertap and Perlick faucets.

Tube length: approx. 315mm once attached to faucet (340mm from end to end)
From: Krome Dispense

Stainless Steel Female Quick Disconnect with 1/2" Female BSP Fitting. Allows you to easily change lines when moving liquids around. 

Includes a food grade O-ring.