30L Fermenter Lid Drilled

This is a must have product if you own a FermZilla or Fermentasaurus and would like to ferment under pressure. With this you can regulate the pressure & therefore carbonation of your fermenter/beer by adjusting the maximum pressure you want it to contain.

The BlowTie Spunding Valve assembly consists of:

• a BlowTie
• a DuoTight Tee Fitting
• a DuoTight to flare fitting
• a MFL gas disconnect
• a pressure gauge
• two small pieces of 8mm tubing

Watch this video on assembly & operation details:

https://www.youtube.com/watch?v=B-sKQJFM6Ak

and about the difference of this product vs the old spunding valve:

https://www.youtube.com/watch?v=f8QDNFQ0E-I

 

Demijohn Handle for 23l

Complete with swivel head and a tapered thread that is compatible with "English" style fermentation barrels. Available in white only.

This is not compatible with the standard 30L plastic fermentation buckets available in NZ.

FastFerment Sampling Port

FastFerment Strap

FastFerment Thermometer

Fermentasaurus – rotating racking arm

This rotating racking arm can be fitted to the Fermentasaurus v1 conical fermenter (or any other fermenting vessel) allowing clear beer to be racked off from the centre of the fermenter. To fit the rotating racking arm you will need to drill a hole into the side of the fermenter; you will also need a 22 mm ring spanner to tighten the nut on the inside of the fermenter.

Note: this prevents the Fermentasaurus from being used as a pressure vessel.

This jacket is designed to insulate your FermZilla 27L fermenter during the colder months to keep your fermentation at the optimum temperature.

It can also be used with a heater belt to warm up the wort if the heat from the fermentation isn't enough.

Completely blocks any light/UV to prevent light-stuck beer.

From: Kegland