Other Homecrafts
-
$12.95Push In Pressure Gauge - 8mm
This push in gauge is ideal to read pressures during pressurised fermentation. The triple scale gauge gives readings in Bar, PSI and kPA so irrespective of what units you prefer this gauge will display what you need.
The barb on this gauge will enable you to put this directly onto hosing or alternatively you can connect it to any of the push in fittings such as the Duotight push in fittings in the 8mm size.
Specifications:
- 0-40psi / 0-250kPa / 0-2.5 Bar (kg/cm^2)
- Rubber Coated
- 8mm Push in Barb
From: KeglandOut of Stock -
$21.70Super Automatica Tirage Bell - 29/31mm (large)
For use on the Red handle "Super Automatica Capper" with Tirage Bells. The standard bell supplied with the Super Automatica Capper is 26mm. This larger 31mm bell is compatible with slightly larger caps and bottle tops.
IMPORTANT: This bell is NOT compatible with the "Green Standard Bench Capper" OR "Lever Bench Capper" - due to different thread size.
-
$4.00Wing Nut for Beer Shank
Chrome plated brass wing nut, often used for attaching a tail piece to a shank. A handy alternative to the standard 5/8" hex nut if you have an application where you wish to be able to disassemble the shank tail piece without using a wrench. -
$5.00Stainless Steel Flange For Shank
Stainless steel flange for standard beer shanks, as an alternative to the standard black plastic option.Out of Stock -
$0.50Silicone Washer Seal - 5/8 for Keg Coupler and Tap Shank
A 5/8" silicone washer seal for Keg Coupler or Tap Shank.
Note: may come in black or white/clear.
Silicone washer seals are easier to get a proper seal but are also easier to damage. If you are looking for a more robust solution consider using a 5/8" neoprene washer instead.Out of Stock -
$8.00Locking Wall Flange for Shank Assembly
The Locking Wall Flange allows you to hold the shank securely in place by fitting three screws that mount the flange to the inside of the door or wall. -
$5.00Faucet Coupling Nut
Chrome plated brass faucet coupling nut to attach a beer tap to a shank. Works with most standard beer fittings.
With this faucet replacement nut you can renew a worn-out part on your well-used draft faucet.Out of Stock -
$50.00Beer Tower Extension - Single to Double (C-516)
The Beer Tower Extension allows you to easily convert an existing single faucet tower into a two faucet tower. Recommended for use on 3" diameter metal beer towers, it includes a shank assembly, a drill bit and 3 screws for installation. -
$10.00Beer Tower Cap
Replacement tower cap for standard 3” beer towers. The cap covers the top of the tower by fitting around the outside. -
$10.00Beer Tower Base Cover
A polished chrome screw cover for a 3" draft beer tower base.
Material: Stainless Steel 304
Finish: Polished
From: Krome Dispense
External diameter of 115mm and an internal diameter of 75mm.
