FermZilla Plastic Pressure Kit - suits both 27L, 55L FermZilla and All rounder fermenters.

This handy little strap will make cleaning and transport your FermZilla All Rounder 30L or 60L an absolute breeze. Simply attach through both sections of the base in the orientation you wish. Slide up and out of the little buckle pieces making sure that the buckle is facing towards you, then strap in and strap down!

The Strap is long enough for the 60L FZ-AR and 30L. We recommend rolling up the excess strap and paper clipping or cutting to suit the 30L. 

Replacement seal kit for the FermZilla 27L and 55L Conical Range

Lid O-ring Also suits the Fermzilla Flat Bottom and All Rounder (for Lid O-ring)

Floating Dip Tube Filter?80 Mesh 304 Stainless) - For FermZilla or Kegmenter.

Made from HDPE and 304 Grade stainless steel, this product can be boiled or sanitised in the full range of cleaners that we sell. The plastic HDPE is over moulded onto the stainless mesh to make a seamless finish. The end cap can easily pop off for cleaning.

The new FTSs quick disconnect kit from Ss Brewtech is the perfect way to increase the efficiency of your cooling system while also making it easier to detach your fermenter's chiller coil for easy cleaning.

From: Ss Brewtech

The Temp Twister allows you to heat and cool your FermZilla or other fermenter or bright tank, ideally by combining with a glycol chiller.

This coil can be adapted to fit any fermenter or bright tank that has an opening of 110mm diameter or larger. Simply drill to two 22mm holes in the lid of your fermenter and use the included Duotight bulkhead fittings to attach the coil to the lid of your fermenter.

Now updated with the all new duotight 8mm Ball Lock Disconnect (Grey+Red/Gas)

This kit has been designed for simplicity and ease of putting together. 

This jacket is designed to insulate your FermZilla 55L fermenter during the colder months to keep your fermentation at the optimum temperature. It can also be used with a heater belt to warm up the wort if the heat from the fermentation isn't enough.

It also completely blocks any light/UV to prevent light stuck beer.

From: Kegland