Fermenters
-
$80.00Ss CIP Spray Ball Tri-Clamp Attachment 3"
CIP Spray Ball Tri-Clamp Attachment
- Made from 304 Stainless Steel
- 3" tri-clamp cap with 1/2" MPT
- 2 bar / 29 psi recommended
- Use on any 3" tri-clamp fitting -
$34.8012L Fermenter Bucket
12L Fermenter Bucket - ideal for small batches.
*Note the lid has no hole and will need to be drilled to fit a airlock and grommet.
-
$59.955L Propylene Glycol - Kegland
Food grade Propylene Glycol (99%) from Kegland in a handy 5 litre container.
Out of Stock -
$1.00Thermowell and FTSs Chiller Coil - Ss Replacement O-Ring
Ss Replacement O-Ring for SS Brewtech Thermowells and FTSs Chiller Coils.
From: Ss Brewing Technologies, USA
A cheap, small but critical part of your brewkit, don't let a damaged o-ring spoil your brewday. -
$10.50FermZilla - Collection Container Removal Tool - Oil Filter Removal Tool - Suits All FermZilla Models
Really handy for tightening and loosening the lids and collection containers or even oil filters from your car. This tool will enable you to easily remove the collection container with the FermZilla or the lid on the FermZilla Flat Bottom, All Rounder and Conical models.
This well made robust tool can also be used for many different sized oil filters in various diameters.
Out of Stock -
$13.95FermZilla Replacement Lid Ring
The two piece lid of this neck ring means that you can tighten the lid with less force.
This quality made and strong engineering plastic lid ring is made from glass reinforced engineering plastics that are not only chemical resistant, heat resistant but also tough as nails so they will last you a lifetime.
This lid ring is made from high quality plastic and will suit any of the FermZilla fermenters, uni tanks, bright tanks.
Out of Stock -
$3.00Chronical - Replacement Racking Arm O-Ring Set
A replacement set of o-rings for standard and Brewmaster Chronical fermenter racking arms. These o-rings also work on Ss Brewtech kettle pickup tubes.
Includes: 10mm x 1.2mm o-ring - set of four.
From: Ss Brewing Technologies, USA
-
$49.95FermZilla Tri-Conical - 3 Inch x 2 Inch Tri-Clamp Butterfly Valve
FermZilla Tri-Conical - 3 Inch x 2 Inch Tri-Clamp Butterfly Valve.
Compatible with the 27L and 55L FermZilla Tri-Conical Series, or any 2 and 3 Inch Tri-Clamp fittings.
-
$939.71Flat Bottom Stainless Tank - 200L
A superbly finished tank in 304 stainless steel with high quality polished internal finish.
Offered with the full VC kit – airlock, pump, tube and floating lid.
Fitted with a welded ¾” BSP socket and are supplied with a stainless steel drain tap.
Out of Stock -
$12.9560cm Thermowell - 1/4inch Duotight Bulkhead Included
This thermowell fits into any 8mm Hole and can literally be installed into almost any fermenter lid.
