Connectors
-
$5.00Duotight Push Fit Tee connector 8mm
This push-fit T-Connector will split the gas (or beer) line on your kegging system in two, allowing you to gas two kegs at the same time. Simple to use and requires no tools. -
$5.00Duotight Push-Fit Elbow 8mm
This Push-Fit Elbow - 8mm x 8mm - will allow you to join beer or gas line sections on your kegging system. Simple to use and requires no tools. -
$5.00Elbow Pipe Joiner 1/4" x 1/4"
Elbow Pipe Joiner for your keg dispensing system. These simple draft beer parts can extend or repair your beer and gas line. -
$5.00Elbow Pipe Joiner 3/16" x 3/16"
Elbow Pipe Joiner for your keg dispensing system. These simple draft beer parts can extend or repair your beer and gas line. Made of stainless steel, they’re designed to maintain the inside diameter of your hose. -
$15.00Elbow Bend - Low Profile - for coupler
This low profile elbow bend sits just 17mm above the top of the keg coupler. This makes it perfect for tight spaces or inside a Kegerator.
Note: You will need a washer/seal if you don't not have one (not included). -
$5.00 -
$5.00Barbed Swivel Nut - 1/4"
A Barbed Swivel Nut, often used for MFL fittings.
Bore size 6.35mm (1/4")Out of Stock -
$4.95Duotight Push In For MFL Connector - 8mm
Easily connect your beer or gas line to your MFL fitting.
Note: MFL keg connector and tubing sold separately.Brand: Duotight
-
$11.00 -
$9.95Stainless MFL Tap Shank Adaptor
The MFL Tap Shank Adaptor is what you need to connect your draft tap directly to your MFL disconnect. These allow you to make a very compact portable setup.
We recommend using one of the Flow Control Nukatap with this adaptor as this provides some restriction of the flow but they will also work with Intertap, Nukatap and other brands of taps. A nylon washer is also recommended between the disconnect and the shank adaptor.
Please bear in mind that due to the compact size there is not enough space to accommodate an auto spring return so it is not compatible that setup.
