Duotight 9.5mm mm x Ball Lock Disconnect (Grey + Red/Gas)

This all new ball lock disconnect sets a new bar! The integrated Duotight design means you can connect your beer and gas line directly, easily and reliably - no need for additional fittings or clamps. It is a robust and super compact design that is incredibly easy to assemble and disassemble, making cleaning and sanitising an absolute breeze!

Made from highly chemical resistant materials with stainless springs and ball bearings - no cheap ABS plastics here - this baby is extremely resistant to commonly used chemicals such as phosphoric based sanitisers and caustics.

Duotight 6.35mm x Ball Lock Disconnect (Black + Yellow/Liquid)

This all new ball lock disconnect sets a new bar! The integrated Duotight design means you can connect your beer and gas line directly, easily and reliably - no need for additional fittings or clamps. It is a robust and super compact design that is incredibly easy to assemble and disassemble, making cleaning and sanitising an absolute breeze!

Made from highly chemical resistant materials with stainless springs and ball bearings - no cheap ABS plastics here - this baby is extremely resistant to commonly used chemicals such as phosphoric based sanitisers and caustics.

Duotight 9.5mm x Ball Lock Disconnect (Black + Yellow/Liquid)

This all new ball lock disconnect sets a new bar! The integrated Duotight design means you can connect your beer and gas line directly, easily and reliably - no need for additional fittings or clamps. It is a robust and super compact design that is incredibly easy to assemble and disassemble, making cleaning and sanitising an absolute breeze!

Made from highly chemical resistant materials with stainless springs and ball bearings - no cheap ABS plastics here - this baby is extremely resistant to commonly used chemicals such as phosphoric based sanitisers and caustics.

This Elbow Piece is suitable for EVABarrier Beer & Gas hosing in 4mm ID & 5mm ID line or most lines with 8mm outer diameter. 

No clamps necessary!

This elbow piece is suitable for EVABarrier Beer & Gas hosing size - 9.5mm (3/8") OD x 6.5mm (1/4") ID

No clamps necessary!

This easy to use and compact spunding valve is handy for keg transfers or pressurized fermentations when you want to limit oxygen exposure and use counter pressure in the keg you are filling into or in the fermenter you are using.

Mini Gauge 0-15psi (0-1.5bar) - for inline Duotight regulator or Blowtie.

This gauge is designed to fit into either our inline regulator or our Blowtie unit. These can be used for water or gas.

Duotight - 8mm shut off ball valve. This is an equal ball valve to take 8mm OD tubing in both sides.

No clamps necessary!

From: Kegland

Flow Control Ball Lock Keg Connector - this is perfect for people who want to serve a large range of beverages with differing carbonation levels as it gives you the ability to adjust resistance easily. This stainless steel ball lock disconnect is machined from stainless steel and has an MFL thread.

If you have a beer of a specific carbonation level you will be required to dispense that beer (if using CO2 to dispense) at a very specific pressure. So you do not have the ability to increase or decrease pressure to change the flow speed out of the tap. For this reason you need to either adjust the beer line length, internal diameter or use flow control devices like this to ensure your beer comes out the tap at the right speed. Ideally between 250-400ml/10 seconds (based on a 10mm ID spout).