Fermenters
-
Sterilock Odour Capsules (4)
For use with the Sterilock Airlock Contains 4 odour absorbing capsules to remove fermentation odours.
Out of Stock -
FermZilla - Jacket for 27L
This jacket is designed to insulate your FermZilla 27L fermenter during the colder months to keep your fermentation at the optimum temperature.
It can also be used with a heater belt to warm up the wort if the heat from the fermentation isn't enough.
Completely blocks any light/UV to prevent light-stuck beer.
Also compatible with 60L All Rounder
From: Kegland
-
Temp Twister Cooling/Heating Coil for FermZilla
The Temp Twister allows you to heat and cool your FermZilla or other fermenter or bright tank, ideally by combining with a glycol chiller.
This coil can be adapted to fit any fermenter or bright tank that has an opening of 110mm diameter or larger. Simply drill to two 22mm holes in the lid of your fermenter and use the included Duotight bulkhead fittings to attach the coil to the lid of your fermenter.
-
Floating Dip Tube FILTER For FermZilla or Kegmenter
Floating Dip Tube Filter?80 Mesh 304 Stainless) - For FermZilla or Kegmenter.
Made from HDPE and 304 Grade stainless steel, this product can be boiled or sanitised in the full range of cleaners that we sell. The plastic HDPE is over moulded onto the stainless mesh to make a seamless finish. The end cap can easily pop off for cleaning.
-
FermZilla Seal Kit (Lid O-ring, Collection Container O-ring and Cone O-Ring)
Replacement seal kit for the FermZilla 27L and 55L Conical Range
Lid O-ring Also suits the Fermzilla Flat Bottom and All Rounder (for Lid O-ring)
-
Bored Bung 19mm - 26mm
Bored Bung 19mm (Barrel) (19mm to 27mm) - red rubber with an airlock hole.
Compatible with the Mangrove Jack's Stainless Stell fermenter. -
Demijohn Solid Bung 28mm-30mm (23L Jar) (28mm to 32mm)
Demijohn Solid Bung 28mm-30mm (23L Jar) (28mm to 32mm)
Fits 23l glass carboys and 5L demijohns.
-
Thermometer Bung 22mm. Black (22mm to 28mm)
Thermometer Bung 22mm. Black (22mm to 28mm). This bung has a smaller diameter bore than a standard bored bung, which makes it suitable for mounting a 30cm Glass Thermometer (available separately). -
Black Grommet for airlock hole in fermenters
A "doughnut" shaped black grommet for the standard airlock hole in plastic fermenters. Compatible with both Senior and Vintage airlock type. Has a centre groove which allows it to clip into the fermenter lid, making it more resistant to being pushed out if pressure builds up during fermentation. -
Rubber stopper / bored bung. #10 w/airlock hole (for plastic carboy)
Rubber stopper / bored bung #10 with airlock hole.
Fits our 11.5l & 23l plastic foodgrade PET carboys perfectly.
#10 size is a standard bung size, in this case 41mm diameter across on the small side, going to 51mm on the wider side.