Equipment
-
2″ tri-clamp Bulkhead assembly
A tri clover fitting that will allow you to connect 2″ tri clover fittings to different vessels and systems. Includes a locknut & o-ring to secure the fitting.
-
Duotight - 8mm OD Retaining Circlip (10 Pack)
Duotight 8mm OD retaining circlip, suits any Duotight 8mm fitting. When clipped into place, this circlip prevents the collar of the Duotight fitting from being pushed inwards, making it impossible for the fitting to release its grip on any hose!
-
1.5” Back nut
316 stainless BSP 1.5” Back nut. Compatible with the DN40 tri-clamp fitting.
Out of Stock -
Duotight - 6.35mm (1/4 inch) x 3/4 inch BSP Thread Female
Duotight - 6.35mm(1/4inch) x 3/4inch BSP Thread Female -
Bsp Reducer 1/2" Male X 1/4" Female
1/2" outer male thread X 1/4" female Reducing bush.
304 stainless steel.
Out of Stock -
Tri-Clamp Gasket
Replacement silicone Tri-Clamp Gasket, suitable for all standard tri-clamp fittings. These are all beaded to fit the tri-clamp groove unless specified otherwise.
Currently available in these sizes:
- 3.81cm (1.5")
- 5.08cm (2") (flat, not beaded)
- 5.08cm (2") - (also used as Grainfather conical plug seal)
- 7.62cm (3")
- 10.16cm (4")
- 15.24cm (6")
- 20.32 (8")
Note: photo shows 7.62cm (3") beaded option. Colour may vary.
-
Camlock Replacement Silicone Seal (5 Pack)
Lost or need to replace a camlock seal? Then purchase this 5 pack, so you can have some back ups up your sleeve!
Material: Silicone