Camlock – Type F male x 1/2 inch male

Stainless Steel - 150psi/11Bar Operating Pressure

Camlock - Male to 1/2" Female (A Type).

Camlock fittings provide an easy way to make connections between your kettles, chillers, pumps, and other parts of your brewery.

Made from: Stainless Steel 316

Camlock – Type B female x 1/2 inch male

Stainless Steel - 150psi/11Bar Operating Pressure

Camlock – Type D female x 1/2 inch female

Stainless Steel - 150psi/11Bar Operating Pressure

Camlock – Type E male x 1/2 inch barb

Stainless Steel - 150psi/11Bar Operating Pressure

Tri-clamp Cap with 13mm Barb

Tri-Clamp (also called Tri Clover) fittings consist of 3 parts: the clamp, the end piece and a silicone gasket. Used in most commercial breweries they are very sturdy. With no nooks or crannies for bacteria/yeast to hide, they clean like a breeze.You can see every surface that meets your precious wort. If that weren't reason enough: they don't leak.

1.5 Inch Tri-Clamp Pressurised Transfer Fitting" 
Tri-Clamp (also called Tri Clover) fittings consist of 3 parts: the clamp, the end piece and a silicone gasket. Used in most commercial breweries they are very sturdy. With no nooks or crannies for bacteria/yeast to hide, they clean like a breeze.You can see every surface that meets your precious wort. If that weren't reason enough: they don't leak.

Fits Chronical Fermenter Lid - 1.5"

Male quick disconnect 13mm barb

Clear lubrication gel for keg parts such as o-rings, couplers, party pumps. Use with plastic and rubber components to avoid cracks and extend their life. Just a little of this goes a long way.