A 1.5" tri-clamp cap to male camlock adapter.

Replacement silicone Tri-Clamp Gasket, suitable for all standard tri-clamp fittings. These are all beaded to fit the tri-clamp groove unless specified otherwise.

Currently available in these sizes:

• 3.81cm (1.5")
• 5.08cm (2") (flat, not beaded)
• 5.08cm (2") - (also used as Grainfather conical plug seal)
• 7.62cm (3")
• 10.16cm (4")
• 15.24cm (6")
•  20.32 (8")

Note: photo shows 7.62cm (3") beaded option. Colour may vary.

Lost or need to replace a camlock seal? Then purchase this 5 pack, so you can have some back ups up your sleeve! 

Material: Silicone 

A tri-clamp cap with a 1/2" female NPT thread. Used to convert a male thread to a tri-clamp connection.

Tri-Clamp Size: 1.5" (3.81cm)
Made from: 304 Stainless Steel

From: Ss Brewtech

A stainless steel Tri-Clamp Cap with 3/8" Barb fitting.

Tri-Clamp (also called Tri Clover) fittings consist of 3 parts: the clamp, the end piece and a silicone gasket. Used in most commercial breweries they are very sturdy. With no nooks or crannies for bacteria/yeast to hide, they clean like a breeze.You can see every surface that meets your precious wort. If that weren't reason enough: they don't leak.

SS O-Ring replacements for Brew Buckets and Mini Brew Buckets.

For use on Brew Bucket 3/8" Ball Valve. Includes:
- 4 pcs 8.5 mm x 1 mm Buna N 70 O-rings
- 2 pcs 16mm x 1.8 mm Buna N 90 O-rings
- 6 pcs total in this set (enough to replace all o-rings on one Brew Bucket valve)

From: Ss Brewing Technologies, USA

Good for hex nipples, and putting pressure on seals.