Now updated with the all new duotight 8mm Ball Lock Disconnect (Grey+Red/Gas)

This kit has been designed for simplicity and ease of putting together. 

The Temp Twister allows you to heat and cool your FermZilla or other fermenter or bright tank, ideally by combining with a glycol chiller.

This coil can be adapted to fit any fermenter or bright tank that has an opening of 110mm diameter or larger. Simply drill to two 22mm holes in the lid of your fermenter and use the included Duotight bulkhead fittings to attach the coil to the lid of your fermenter.

A replacement set of o-rings for standard and Brewmaster Chronical fermenter racking arms. These o-rings also work on Ss Brewtech kettle pickup tubes.

Includes: 10mm x 1.2mm o-ring - set of four. 

From: Ss Brewing Technologies, USA

FermZilla Tri-Conical - 3 Inch x 2 Inch Tri-Clamp Butterfly Valve.

Compatible with the 27L and 55L FermZilla Tri-Conical Series, or any 2 and 3 Inch Tri-Clamp fittings.

This handy little strap will make cleaning and transport your FermZilla All Rounder 30L or 60L an absolute breeze. Simply attach through both sections of the base in the orientation you wish. Slide up and out of the little buckle pieces making sure that the buckle is facing towards you, then strap in and strap down!

The Strap is long enough for the 60L FZ-AR and 30L. We recommend rolling up the excess strap and paper clipping or cutting to suit the 30L. 

FermZilla - Conical - Replacement Dual Threaded Cone Piece, Cone Ring Nut, Cone Gasket

This replacement kit is compatible with:

FermZilla 27L - Conical Fermenter

FermZilla 35L - Conical Fermenter

FermZilla 55L - Conical Fermenter

O-Ring included and attached on the Dual Threaded Cone Piece

This replacement Gate Gasket is compatible with: 

FermZilla 27L - Conical Fermenter

FermZilla 35L - Conical Fermenter

FermZilla 55L - Conical Fermenter

Replacement seal kit for the FermZilla 27L and 55L Conical Range

Lid O-ring Also suits the Fermzilla Flat Bottom and All Rounder (for Lid O-ring)