This thermowell fits into any 8mm Hole and can literally be installed into almost any fermenter lid.

The MFL Tap Shank Adaptor is what you need to connect your draft tap directly to your MFL disconnect. These allow you to make a very compact portable setup.

We recommend using one of the Flow Control Nukatap with this adaptor as this provides some restriction of the flow but they will also work with Intertap, Nukatap and other brands of taps. A nylon washer is also recommended between the disconnect and the shank adaptor.

Please bear in mind that due to the compact size there is not enough space to accommodate an auto spring return so it is not compatible that setup.

For use on the Red handle "Super Automatica Capper" with Tirage Bells. The standard bell supplied with the Super Automatica Capper is 26mm. This larger 31mm bell is compatible with slightly larger caps and bottle tops.

IMPORTANT: This bell is NOT compatible with the "Green Standard Bench Capper"  OR "Lever Bench Capper" - due to different thread size.

Chrome plated brass wing nut, often used for attaching a tail piece to a shank. A handy alternative to the standard 5/8" hex nut if you have an application where you wish to be able to disassemble the shank tail piece without using a wrench.

Stainless steel flange for standard beer shanks, as an alternative to the standard black plastic option.

A 5/8" silicone washer seal for Keg Coupler or Tap Shank.

Note: may come in black or white/clear.

Silicone washer seals are easier to get a proper seal but are also easier to damage. If you are looking for a more robust solution consider using a 5/8" neoprene washer instead.

The Locking Wall Flange allows you to hold the shank securely in place by fitting three screws that mount the flange to the inside of the door or wall.

Chrome plated brass faucet coupling nut to attach a beer tap to a shank. Works with most standard beer fittings.
With this faucet replacement nut you can renew a worn-out part on your well-used draft faucet.

The Beer Tower Extension allows you to easily convert an existing single faucet tower into a two faucet tower. Recommended for use on 3" diameter metal beer towers, it includes a shank assembly, a drill bit and 3 screws for installation.