Food grade Polyethylene Washers designed for the Air Still Filter and the Air Still Fermenter Lid. Ideal for use with alcohol as Polyethylene will not taint alcohol.

Comes in a pack of 10.

FermZilla Plastic Pressure Kit - suits both 27L, 55L FermZilla and All rounder fermenters.

This jacket is designed to insulate your FermZilla 55L fermenter during the colder months to keep your fermentation at the optimum temperature. It can also be used with a heater belt to warm up the wort if the heat from the fermentation isn't enough.

It also completely blocks any light/UV to prevent light stuck beer.

From: Kegland

Floating Dip Tube Filter?80 Mesh 304 Stainless) - For FermZilla or Kegmenter.

Made from HDPE and 304 Grade stainless steel, this product can be boiled or sanitised in the full range of cleaners that we sell. The plastic HDPE is over moulded onto the stainless mesh to make a seamless finish. The end cap can easily pop off for cleaning.

FermZilla - Conical - Replacement Dual Threaded Cone Piece, Cone Ring Nut, Cone Gasket

This replacement kit is compatible with:

FermZilla 27L - Conical Fermenter

FermZilla 35L - Conical Fermenter

FermZilla 55L - Conical Fermenter

O-Ring included and attached on the Dual Threaded Cone Piece

This handy little strap will make cleaning and transport your FermZilla All Rounder 30L or 60L an absolute breeze. Simply attach through both sections of the base in the orientation you wish. Slide up and out of the little buckle pieces making sure that the buckle is facing towards you, then strap in and strap down!

The Strap is long enough for the 60L FZ-AR and 30L. We recommend rolling up the excess strap and paper clipping or cutting to suit the 30L. 

Replacement Thermal Reset Switch for Grainfather/T500 Boiler

This listing is for 1 x reset switch.

FermZilla Tri-Conical - 3 Inch x 2 Inch Tri-Clamp Butterfly Valve.

Compatible with the 27L and 55L FermZilla Tri-Conical Series, or any 2 and 3 Inch Tri-Clamp fittings.

A replacement set of o-rings for standard and Brewmaster Chronical fermenter racking arms. These o-rings also work on Ss Brewtech kettle pickup tubes.

Includes: 10mm x 1.2mm o-ring - set of four. 

From: Ss Brewing Technologies, USA