Connections and Valves
-
$34.95 -
$12.95Tri-Clamp Cap with 1/4" Barb
Stainless steel tri-clamp cap (1.5") to 1/4″ (6.35mm) Hose Barb.
- Made out of 304 Stainless Steel
- 1/4″ OD Hose Barb
- Designed for use with 1/4″ ID tubing
-
$18.95Hole Plug - 22mm for Ss Brewtech Kettle
A 22mm Hole Plug with o-rings and attachment nut, used to plug thermometer, ball valve, and kettle top recirculation holes on Ss Brewtech kettles.
-
$7.95Tri-Clamp Blank
A stainless steel plate to close, or blank off an outlet. Sometimes it is referred to as a blind cap.
Currently available in these sizes:
- 1.5" (3.81cm)
- 2" (5.08cm)
- 3" (7.62cm) -
$16.95 -
$12.95Keg Lube
Clear lubrication gel for keg parts such as o-rings, couplers, party pumps. Use with plastic and rubber components to avoid cracks and extend their life. Just a little of this goes a long way.Out of Stock -
$49.95FermZilla Tri-Conical - 2" x 2" Tri-Clamp Butterfly Valve
Compatible with any 2 Inch tri-clamp fitting. Primarily designed for the:
- FermZilla 2" Tri-Clamp Lid
- in conjunction with the 2" Tri-Clamp Hop Bong
If you are looking to put your FermZilla Tri-Conical / All Rounder in a Fermentation Chamber / Fridge, you will want to allow 420mm measured from the base of the ring collar to a comfortable level to pull the pressure relief valve to purge oxygen from the hop bong. -
New$3.95Duotight - 8mm OD Retaining Circlip (10 Pack)
Duotight 8mm OD retaining circlip, suits any Duotight 8mm fitting. When clipped into place, this circlip prevents the collar of the Duotight fitting from being pushed inwards, making it impossible for the fitting to release its grip on any hose!
Out of Stock -
$9.95 -
$14.00
