Stainless steel tri-clamp cap (1.5") to 1/4″ (6.35mm) Hose Barb.

• Made out of 304 Stainless Steel
• 1/4″ OD Hose Barb
• Designed for use with 1/4″ ID tubing

A 22mm Hole Plug with o-rings and attachment nut, used to plug thermometer, ball valve, and kettle top recirculation holes on Ss Brewtech kettles.

A stainless steel plate to close, or blank off an outlet. Sometimes it is referred to as a blind cap.

Currently available in these sizes:
- 1.5" (3.81cm)
- 2" (5.08cm)
- 3" (7.62cm)

A 1.5" tri-clamp cap to male camlock adapter.

Compatible with any 2 Inch tri-clamp fitting. Primarily designed for the:
- FermZilla 2" Tri-Clamp Lid
- in conjunction with the 2" Tri-Clamp Hop Bong

If you are looking to put your FermZilla Tri-Conical / All Rounder in a Fermentation Chamber / Fridge, you will want to allow 420mm measured from the base of the ring collar to a comfortable level to pull the pressure relief valve to purge oxygen from the hop bong.

Duotight 8mm OD retaining circlip, suits any Duotight 8mm fitting. When clipped into place, this circlip prevents the collar of the Duotight fitting from being pushed inwards, making it impossible for the fitting to release its grip on any hose!

A Tri-Clamp fitting made from 304 stainless steel - available in different sizes.