These copper counter flow chillers are probably one of the fastest ways to chill wort. They are similarly efficient as the 30 plate chillers however they are easier to clean as they do not have all the small crevasses to trap hop material and othersolids. 

The copper is a very good conductor of heat. These units are 23cm in diameter and about 18cm high. The input and output are approximately 10mm outside diameter. These can be used with gravity but are recommended to use with a pump.

Upgrade your RoboBrew Chiller with a Counterflow chiller to rapidly chill your wort without the messy clean up!

Duotight 9.5mm fittings push onto the copper fittings, giving you lots of options to connect hoses. We recommend using 9.5mm x 1/2" male threaded fittings, and male camlock to 1/2" female threaded fittings to make an easy to connect setup!