Other Homecrafts
-
$4.95Duotight - 9.5mm (3/8”) Female x 9.5mm (3/8”) Female Bulkhead with 20mm Locknut
These high quality acetal fittings are made with EPDM o-rings that are reliable, will not perish like cheaper rubber. The acetal plastic is also chemical and UV resistant so it will last for a long time even in testing conditions.
This product is ideally suited to the 9.5mm (3/8") EVABarrier tubing.
-
$9.95Keg Connector - 6.35mm Duotight - Gas
Duotight 6.35mm x Ball Lock Disconnect (Grey + Red/Gas)
This all new ball lock disconnect sets a new bar! The integrated Duotight design means you can connect your beer and gas line directly, easily and reliably - no need for additional fittings or clamps.
-
$9.95Keg Connector - 9.5mm Duotight - Gas
Duotight 9.5mm mm x Ball Lock Disconnect (Grey + Red/Gas)
This all new ball lock disconnect sets a new bar! The integrated Duotight design means you can connect your beer and gas line directly, easily and reliably - no need for additional fittings or clamps.
-
$4.95Duotight - 9.5mm (3/8) Female x 9.5mm (3/8) Female Joiner
This push in joiner is suitable for our EVABarrier Beer & Gas hosing in 9.5mm (3/8") OD line.
No clamps necessary!
-
$4.95Duotight - 9.5mm (3/8) Female x 1/2 Male Thread
This piece is suitable for EVABarrier Beer & Gas hosing in 9.5mm (3/8") OD line to 6.5mm (1/4") OD to male 1/2" BSP Thread. Perfect for attaching to this copper counter flow chiller.
-
$4.95Duotight - 9.5mm (3/8) Female x 5/8 Female Thread (suits Keg Couplers and Tap Shanks)
This straight joiner is suitable for our EVABarrier Beer & Gas hosing in 6mm x 9.5mm line. This allows a direct duotight push fitting to attach directly to a keg coupler.
No clamps necessary!
Out of Stock -
$5.00Duotight - 8mm Ball Valve
Duotight - 8mm shut off ball valve. This is an equal ball valve to take 8mm OD tubing in both sides.
No clamps necessary!
From: Kegland -
$5.00Duotight - 8mm Push-Fit Check Valve
Duotight 8mm (5/16) one way check valve/non-return valve.
From: Kegland -
$9.00Tail Piece with 1/4" MFL Connector
Tail piece for your dispensing system that provides a 1/4" MFL connector instead of a barb.
From: Krome Dispense
Material: 304 grade stainless steel
Looking for the full setup? Designed to be used with a 5/8" hex nut and a 5/8" neoprene washer. These items sold separately. -
$5.00Duotight Push Fit Tee connector 8mm
This push-fit T-Connector will split the gas (or beer) line on your kegging system in two, allowing you to gas two kegs at the same time. Simple to use and requires no tools.
