Cider, Seltzer, Mead, Kombucha and Ginger Beer
-
New$7.6030L Boiler large Silcone Bung
Silicon bung specially designed to fit hole in 48mm boiler lid.
45MM x 49MM
-
$4.95Duotight - 9.5mm (3/8) Female x 9.5mm (3/8) Female Tee Piece
This tee piece is suitable for EVABarrier Beer & Gas hosing size - 9.5mm (3/8") OD x 6.5mm (1/4") ID
No clamps necessary!
Out of Stock -
$4.95Duotight - 8mm Push Fit to 5/8"
Duotight push in fitting for 8mm line to 5/8" thread - ideal for keg couplers and tap shanks.
-
$6.30 -
$4.95Duotight Push In For MFL Connector - 8mm
Easily connect your beer or gas line to your MFL fitting.
Note: MFL keg connector and tubing sold separately.Brand: Duotight
Out of Stock -
$5.00Duotight - 8mm Ball Valve
Duotight - 8mm shut off ball valve. This is an equal ball valve to take 8mm OD tubing in both sides.
No clamps necessary!
From: Kegland -
$5.00Duotight - 8mm Push-Fit Check Valve
Duotight 8mm (5/16) one way check valve/non-return valve.
From: KeglandOut of Stock -
$9.00Tail Piece with 1/4" MFL Connector
Tail piece for your dispensing system that provides a 1/4" MFL connector instead of a barb.
From: Krome Dispense
Material: 304 grade stainless steel
Looking for the full setup? Designed to be used with a 5/8" hex nut and a 5/8" neoprene washer. These items sold separately. -
$5.00Duotight Push Fit Tee connector 8mm
This push-fit T-Connector will split the gas (or beer) line on your kegging system in two, allowing you to gas two kegs at the same time. Simple to use and requires no tools. -
$5.00Duotight Push-Fit Elbow 8mm
This Push-Fit Elbow - 8mm x 8mm - will allow you to join beer or gas line sections on your kegging system. Simple to use and requires no tools.
