Traditional analogue gauges require a small capillary mechanism where a small pipe expands and unravels under pressure. This in turn drives a mechanical cog to rotate the gauge needle.  This age old technique works quite well especially in large gauges but as this mechanism is manufactured smaller and smaller a tradeoff between accuracy and size becomes the issue.  With very small gauges such as a 27mm x 27mm Mini Gauge it's difficult to make them better than 10% accuracy due to the physical constraints of the mechanical components.

A gas distributor for splitting your CO2 gas line into multiple outlets, with MFL connections. Options for two, three, and four outlets.

Connect just one cylinder to this gas distributor inlet and dispense from many beer kegs – all at the same time. You get the same pressure at all outlet points.

Stainless Steel 304 Wall Mounting Brackets and Screws Included.

These can be used with any kegerator as they are compatible with gas bottles with a standard thread. To use it with the new kegerators, you just need to remove the hose barb.

A stainless steel gauge guard for MK4 regulators (Bump Guard).

Are you like us and bump and push in your kegerator too hard up against the wall with the gas bottle on the back, maybe you've broken a dial in the process of dropping or transporting your gas bottle with the regulator attached. Or perhaps you're in a busy cafe/bar and someone needs to change over the tank and they drop the regulator, smashing the dial. That's money wasted and time spent without whats on tap. If you're like us then you need our tough stainless steel regulator bump, bash, smash and drop (within reason) guard protector. Designed and built by those who are tired of replacing gauge and getting refills for a simple accident.

Unlike most Gauge Guards/Gauge Cages this particular design is made completely from one piece of 304 stainless steel so it won't rust over time.

The Duotight Inline Regulator - these compact inline regulators have been designed to suit 8mm (5/16") tubing.

Suits pressures 0-150psi however this unit is packed with the 0-60psi gauge as standard. Suitable for mains water pressure, also suitable for liquid or gas.

Unlike our cheaper sodastream cylinder adaptors, this adapter has the added advantage that you can use the side thumb screw to depress the pin in the middle of the adaptor.  This pin adjustment makes the sodastream cylinder adaptor significantly easier to use.

This push in gauge is ideal to read pressures during pressurised fermentation. The triple scale gauge gives readings in Bar, PSI and kPA so irrespective of what units you prefer this gauge will display what you need.

The barb on this gauge will enable you to put this directly onto hosing or alternatively you can connect it to any of the push in fittings such as the Duotight push in fittings in the 8mm size.

Specifications:
- 0-40psi / 0-250kPa / 0-2.5 Bar (kg/cm^2)
- Rubber Coated
- 8mm Push in Barb

From: Kegland

Need to set two different CO2 pressures for different beers on tap? Then you'll need two regulators to do it properly. With this MK4 Dual Pressure Regulator you'll be able to screw it into your CO2 bottle and fire away with two different pressures. No need to removing the High Pressure gauge off one regulator, buying an attachment and joining the two together.

See - Single CO2 Regulator - MK4 for the single version of this regulator.

A CO2 Gas Cylinder Holder for securing one cylinder.

Simply mount onto the wall or similar (screws not included) and use the chain to wrap around the cylinder.