Fermenter Parts and Accessories
-
Floating Dip Tube FILTER For FermZilla or Kegmenter
Floating Dip Tube Filter?80 Mesh 304 Stainless) - For FermZilla or Kegmenter.
Made from HDPE and 304 Grade stainless steel, this product can be boiled or sanitised in the full range of cleaners that we sell. The plastic HDPE is over moulded onto the stainless mesh to make a seamless finish. The end cap can easily pop off for cleaning.
-
Fermzilla Replacement Lid
A replacement FermZilla lid, made from high quality plastic, chemical resistant and heat resistant.
This lid will suit any of the FermZilla fermenters, uni tanks, bright tanks. It will suit:
FermZilla 27L - Conical Fermenter
FermZilla 35L - Conical Fermenter
FermZilla 55L - Conical Fermenter
FermZilla 27L - Flat Bottom
FermZilla 55L - Flat Bottom
FermZilla 27L - Bright Tank
FermZilla 55L - Bright TankNote: does not include the FermZilla lid ring that holds this down
From: Kegland
-
FermZilla - Conical - Replacement 27L Tank
You might be saying to yourself "Ahhh bugger! It was too hot..." and now you're here! Don't worry we have replacement tanks available for purchase. These are all pre-drilled and as clean as whistle.
Out of Stock -
FermZilla Lid O-ring
FermZilla - Conical - Seal Kit (Lid O-ring, Dump Valve Spigot O-Ring and Collection Container O-ring) -
FermZilla - Conical - Replacement Cone Gasket
This replacement Gate Gasket is compatible with:
FermZilla 27L - Conical Fermenter
FermZilla 35L - Conical Fermenter
FermZilla 55L - Conical Fermenter
-
FermZilla - Conical - Replacement Dual Threaded Cone Piece, Cone Ring Nut, Cone Gasket
FermZilla - Conical - Replacement Dual Threaded Cone Piece, Cone Ring Nut, Cone Gasket
This replacement kit is compatible with:
FermZilla 27L - Conical Fermenter
FermZilla 35L - Conical Fermenter
FermZilla 55L - Conical Fermenter
O-Ring included and attached on the Dual Threaded Cone Piece
-
PCO1881 x PCO1881 Female Ball Valve - Dry Hop Device for FermZilla
This really handy stainless adaptor ball valve will enable you to connect two PCO 1881 threads with a valve in between. Each side has an integrated O-ring that will seal on the neck of the PCO1881 Thread. Ideally suited to making a dry hop device for FermZilla.
Out of Stock -
Ss CIP Spray Ball Tri-Clamp Attachment 3"
CIP Spray Ball Tri-Clamp Attachment
- Made from 304 Stainless Steel
- 3" tri-clamp cap with 1/2" MPT
- 2 bar / 29 psi recommended
- Use on any 3" tri-clamp fitting