Equipment
-
$4.95Duotight - 8mm (5/16") Female x 8mm (5/16") Female with Bulkhead 20mm Locknut
These high quality acetal fittings are made with EPDM o-rings that are reliable, will not perish like cheaper rubber. The acetal plastic is also chemical and UV resistant so it will last for a long time even in testing conditions.
This product is ideally suited to the 8mm (3/8") EVABarrier tubing.
-
$4.95Duotight - 9.5mm (3/8) Female x 9.5mm (3/8) Female Elbow
This elbow piece is suitable for EVABarrier Beer & Gas hosing size - 9.5mm (3/8") OD x 6.5mm (1/4") ID
No clamps necessary!
Out of Stock -
$4.95Duotight - 9.5mm (3/8) Female x 9.5mm (3/8) Female Tee Piece
This tee piece is suitable for EVABarrier Beer & Gas hosing size - 9.5mm (3/8") OD x 6.5mm (1/4") ID
No clamps necessary!
Out of Stock -
$4.95Duotight - 9.5mm (3/8) Female x 9.5mm (3/8) Female Joiner
This push in joiner is suitable for our EVABarrier Beer & Gas hosing in 9.5mm (3/8") OD line.
No clamps necessary!
-
$4.95Duotight Push In For MFL Connector - 8mm
Easily connect your beer or gas line to your MFL fitting.
Note: MFL keg connector and tubing sold separately.Brand: Duotight
-
$5.00Duotight - 8mm Ball Valve
Duotight - 8mm shut off ball valve. This is an equal ball valve to take 8mm OD tubing in both sides.
No clamps necessary!
From: Kegland -
$5.00Duotight - 8mm Push-Fit Check Valve
Duotight 8mm (5/16) one way check valve/non-return valve.
From: Kegland -
$9.00Tail Piece with 1/4" MFL Connector
Tail piece for your dispensing system that provides a 1/4" MFL connector instead of a barb.
From: Krome Dispense
Material: 304 grade stainless steel
Looking for the full setup? Designed to be used with a 5/8" hex nut and a 5/8" neoprene washer. These items sold separately. -
$5.00Duotight Push Fit Tee connector 8mm
This push-fit T-Connector will split the gas (or beer) line on your kegging system in two, allowing you to gas two kegs at the same time. Simple to use and requires no tools. -
$5.00Duotight Push-Fit Elbow 8mm
This Push-Fit Elbow - 8mm x 8mm - will allow you to join beer or gas line sections on your kegging system. Simple to use and requires no tools.
