DIY Tap Handle Inserts - Dual Threaded - 3/8″-16 threads, .625″ Length.

Want to make your own unique tap handles but the thread type is strange? These simplistic brass inserts are the answer.

All you'll need is a 12.7mm (1/2") hole drilled into your handle (Pine, Red Gum, Oak, Cherry, Maple, etc), then screw in with a large flat screw driver.

It is important not to push down too hard if you're going to using a screw driver, or wide drill bit. It will strip the thread. Let the piece cut into the wood. Ensure that it is straight.

Suits NukaTap and Intertap taps

A stainless steel gauge guard for MK4 regulators (Bump Guard).

Are you like us and bump and push in your kegerator too hard up against the wall with the gas bottle on the back, maybe you've broken a dial in the process of dropping or transporting your gas bottle with the regulator attached. Or perhaps you're in a busy cafe/bar and someone needs to change over the tank and they drop the regulator, smashing the dial. That's money wasted and time spent without whats on tap. If you're like us then you need our tough stainless steel regulator bump, bash, smash and drop (within reason) guard protector. Designed and built by those who are tired of replacing gauge and getting refills for a simple accident.

Unlike most Gauge Guards/Gauge Cages this particular design is made completely from one piece of 304 stainless steel so it won't rust over time.

A CO2 Gas Cylinder Holder for securing one cylinder.

Simply mount onto the wall or similar (screws not included) and use the chain to wrap around the cylinder.

Need to set two different CO2 pressures for different beers on tap? Then you'll need two regulators to do it properly. With this MK4 Dual Pressure Regulator you'll be able to screw it into your CO2 bottle and fire away with two different pressures. No need to removing the High Pressure gauge off one regulator, buying an attachment and joining the two together.

See - Single CO2 Regulator - MK4 for the single version of this regulator.

Unlike our cheaper sodastream cylinder adaptors, this adapter has the added advantage that you can use the side thumb screw to depress the pin in the middle of the adaptor.  This pin adjustment makes the sodastream cylinder adaptor significantly easier to use.

This easy to use SodaStream Cylinder Filling Adaptor will enable you to fill your own CO2 from your larger bulk cylinder into smaller SodaStream cylinders. An easy and inexpensive way to fill your own Sodastream Cylinders at home at a fraction of the cost of getting the refills from your local store.

See this video for full instructions: https://www.youtube.com/watch?v=MeopdQRJPTA

The Duotight Inline Regulator - these compact inline regulators have been designed to suit 8mm (5/16") tubing.

Suits pressures 0-150psi however this unit is packed with the 0-60psi gauge as standard. Suitable for mains water pressure, also suitable for liquid or gas.

Inert Gas Regulator for Disposable Cylinders (N2 - Nitrogen, Ar - Argon, CO2 Compatible with M10 Thread).