Equipment
-
$12.95Cornelius Type Ball Lock Post with 1/2" Male Thread
A ball lock keg post with 1/2? male thread, used on Mytton Rodd kegs but could be used on ball valves or tri-clamp fittings with 1/2" thread. -
$60.65Ball Lock Tapping Head to 2inch Tri-Clover (Commercial Keg Adaptor)
Most commercial kegs will use a traditional type keg spear like d-type keg spear (American Sankey) or the a-type keg spear (German Slider). These keg spears have been designed for commercial use and will use larger and high flow rate commercial keg.
Out of Stock -
$6.95Ball Lock Keg Liquid Jumper Post - Double Ended Corny Post <br><small style=
We've seen some nifty tricks of how people wash their Kegerator lines if they have multiple taps. This compact solution is going to make that routine cleaning day a breeze without having to swap disconnects to the cleaning keg/bottle or dismantling multiple ball locks. Just jump on the jumper post.
This double ended cornelius post does not have a spring / poppet. It just has a piece of bar that activates the ball lock disconnect wide open.
This double ended post will only work with liquid Ball Lock posts. e.g. The Premium Ball Lock in Black MFL and Barb, the Machined and Cast Stainless Steel disconnects in barb and MFL.
Please note it is a single piece that cannot be undone from the middle.Out of Stock -
$7.95Keg Lid Pressure Relief Valve (grey) - 100 PSI
Replacement pressure relief valve (PRV) for corny kegs, MK4 Regulators, and FermZilla Lids.
This model is the grey - 100 PSI version, also available in 35 and 65 PSI versions.
-
$7.95Keg Lid Pressure Relief Valve (green) - 65 PSI
Replacement pressure relief valve (PRV) for corny kegs, MK4 Regulators, and FermZilla Lids.
This model is the green - 65 PSI version, also available in 35 and 100 PSI versions.
-
$12.95Dip Tube For Corny Kegs - Liquid
Replacement liquid dip tube for 19L corny kegs. If you need one for a 9.5L keg, then simply cut it down to length. Don't cut it too short, because it's much harder to make it longer than it is to make it shorter.
Out of Stock -
$7.50Coupler main (bottom) O-ring - No.9
Micromatic Coupler replacement O-ring. Micromatic couplers are a good quality coupler used in many commercial and home environments. This is a replacement seal for when the original seal gets worn out. -
$0.50Pressure Relief Valve O-ring
8mm x 5mm (metric) 3/16" x 5/16" (imperial) - perfect fit for replacing the o-ring on cornelius type lid pressure relief valvesOut of Stock -
$0.50Poppet O-ring
6mm OD x 3mm ID (metric) 1/4"x1/8" (imperial) o-ring for replacing poppet seals on corny type keg posts.
Out of Stock -
$29.95Ball Valve - Three-Piece 1/2"
A 3-piece, full bore stainless steel ball valve complete with locking handle. It has female BSP threads at each end. Being 3-piece it is also easy to disassemble and clean.
