Seal Kit - duotight 8mm x Flow Control Ball Lock Disconnect

Please refer to the product photos for an exploded diagram of where the replacement seals and poppet placement. 

Duotight 8mm x Flow Control Ball Lock Disconnect (Black-Yellow/Liquid).

This all new ball lock disconnect sets a new bar! The integrated duotight design means you can connect your beer line directly, easily and reliably - no need for additional fittings or clamps. It is a robust and super compact compared to the previous Stainless Steel Flow Control Ball Lock that has been discontinued due to the difficulty in repeated tooling and overall cost of raw materials.

These high quality acetal fittings are made with EPDM o-rings that are reliable, will not perish like cheaper rubber. The acetal plastic is also chemical and UV resistant so it will last for a long time even in testing conditions.

This beer line tidy is a handle little part that will help you organise your beer and gas line inside your fridge, keezer, kegerator or cellar. This keeps your beer and gas plumbing neat and tidy so your draft system looks as good as it works. Designed to suit both 8mm outer diameter hosing like 4mm x 8mm EVABarrier and 5mm x 8mm EVABarrier hosing. It can also fit smaller 3mm x 6.35mm EVABarrier hosing but may slip out more easily than the standard 8mm outer diameter hosing.

Simply remove the was paper and use the strong 3M adhesive to attach this beer/gas line organiser to whatever device you like.

These high quality acetal fittings are made with EPDM o-rings that are reliable, will not perish like cheaper rubber. The acetal plastic is also chemical and UV resistant so it will last for a long time even in testing conditions.

This product is ideally suited to the 8mm (3/8") EVABarrier tubing.

These high quality acetal fittings are made with EPDM o-rings that are reliable, will not perish like cheaper rubber. The acetal plastic is also chemical and UV resistant so it will last for a long time even in testing conditions.

This product is ideally suited to the 9.5mm (3/8") EVABarrier tubing.

6mm hose barb X 1/8 bsp thread (brass)

This fitting is compatible with Mangrove Jack's mini regulator allowing a gas line to feed from the regulator to the keg. (no direct keg mount)
Works with the Portable Dispencing kit also.
Note you need thread tape for the above application.

Duotight push in fitting for 8mm line to 5/8" thread - ideal for keg couplers and tap shanks.

A barbed stainless steel T (tee) piece for splitting a keg line.

Bore size:
6.35mm (1/4")