This bulkhead allows you to add a 1.5" tri-clamp flange to virtually any vessel.

• Weldless design
• Ideal for FTSs and Brew Bucket flat lid pressurised transfers
• Use with Pressurised Transfer Fitting 
• 304 Stainless Construction
• High heat compatible silicone O-ring

These hole punches are great for making really clean holes that are free of burrs. The holes made with this type of punch are significantly better than a hole made with a carbide drill bit or many other hole saws. These produce clean holes and can be used in mild sheet steel up to 3mm thick or stainless steel up to about 1.5mm thick. If you are looking for a really easy way to make really clean holes this is the best product for the job.

Available for a 22mm or 32mm hole.

Tri-Clamp Cap With 17mm Blow-Off Hole and Pressure Relief Valve

Note: Do not buy if you purchased a Brewmaster Edition Chronical fermenter as it comes standard.

- Size: 7.62cm (3")
- Material: 304 Stainless Steel
- Includes custom fabricated 1/2" stainless hose barb
- 17mm hole for 1/2" tubing
- Pressure relief valve included - 3" TC gasket not included

From: Ss Brewtech

Good for hex nipples, and putting pressure on seals.

SS O-Ring replacements for Brew Buckets and Mini Brew Buckets.

For use on Brew Bucket 3/8" Ball Valve. Includes:
- 4 pcs 8.5 mm x 1 mm Buna N 70 O-rings
- 2 pcs 16mm x 1.8 mm Buna N 90 O-rings
- 6 pcs total in this set (enough to replace all o-rings on one Brew Bucket valve)

From: Ss Brewing Technologies, USA

A stainless steel Tri-Clamp Cap with 3/8" Barb fitting.

Tri-Clamp (also called Tri Clover) fittings consist of 3 parts: the clamp, the end piece and a silicone gasket. Used in most commercial breweries they are very sturdy. With no nooks or crannies for bacteria/yeast to hide, they clean like a breeze.You can see every surface that meets your precious wort. If that weren't reason enough: they don't leak.