Equipment
-
$9.95Ball Lock Keg Liquid Jumper Post - Double Ended Corny Post
We've seen some nifty tricks of how people wash their Kegerator lines if they have multiple taps. This compact solution is going to make that routine cleaning day a breeze without having to swap disconnects to the cleaning keg/bottle or dismantling multiple ball locks. Just jump on the jumper post.
-
$7.95Keg Lid Pressure Relief Valve (grey) - 100 PSI
Replacement pressure relief valve (PRV) for corny kegs, MK4 Regulators, and FermZilla Lids.
This model is the grey - 100 PSI version, also available in 35 and 65 PSI versions.
-
$7.95Keg Lid Pressure Relief Valve (green) - 65 PSI
Replacement pressure relief valve (PRV) for corny kegs, MK4 Regulators, and FermZilla Lids.
This model is the green - 65 PSI version, also available in 35 and 100 PSI versions.
-
$12.95Dip Tube For Corny Kegs - Liquid
Replacement liquid dip tube for 19L corny kegs. If you need one for a 9.5L keg, then simply cut it down to length. Don't cut it too short, because it's much harder to make it longer than it is to make it shorter.
-
$7.50Coupler main (bottom) O-ring - No.9
Coupler replacement (bottom) O-ring. Keg couplers are used in many commercial and home environments.
This is a replacement seal for when the original seal gets worn out.Compatible with Micromatic and all 'D and S' type couplers.
Dimensions: 24MM ID x 33.5MM OD
-
$1.00Pressure Relief Valve O-ring
8mm x 5mm (metric) 3/16" x 5/16" (imperial) - perfect fit for replacing the o-ring on cornelius type lid pressure relief valves -
$1.00Poppet O-ring
6mm OD x 3mm ID (metric) 1/4"x1/8" (imperial) o-ring for replacing poppet seals on corny type keg posts.
-
$29.95Ball Valve - Three-Piece 1/2"
A 3-piece, full bore stainless steel ball valve complete with locking handle. It has female BSP threads at each end. Being 3-piece it is also easy to disassemble and clean. -
$17.801.5” Tri-Clamp cap with 3/4” BSP female
1.5” Tri-Clamp cap with 3/4” BSP female
Tri-Clamp (also called Tri Clover) fittings consist of 3 parts: the clamp, the end piece and a silicone gasket. Used in most commercial breweries they are very sturdy. With no nooks or crannies for bacteria/yeast to hide, they clean like a breeze.You can see every surface that meets your precious wort. If that weren't reason enough: they don't leak. -
$10.0012.7mm Stainless Steel Compression Fitting 1/2” BSP
A 12.7mm compression fitting with 1/2" BSP thread.
These compression fittings are commonly used with immersion chillers to quickly disconnect the liquid hosing for storage and ease of cleaning.
