Duotight 8mm OD retaining circlip, suits any Duotight 8mm fitting. When clipped into place, this circlip prevents the collar of the Duotight fitting from being pushed inwards, making it impossible for the fitting to release its grip on any hose!

A stainless steel plate to close, or blank off an outlet. Sometimes it is referred to as a blind cap.

Currently available in these sizes:
- 1.5" (3.81cm)
- 2" (5.08cm)
- 3" (7.62cm)

A 1.5" tri-clamp cap to male camlock adapter.

Replacement silicone Tri-Clamp Gasket, suitable for all standard tri-clamp fittings. These are all beaded to fit the tri-clamp groove unless specified otherwise.

Currently available in these sizes:

• 3.81cm (1.5")
• 5.08cm (2") (flat, not beaded)
• 5.08cm (2") - (also used as Grainfather conical plug seal)
• 7.62cm (3")
• 10.16cm (4")
• 15.24cm (6")
•  20.32 (8")

Note: photo shows 7.62cm (3") beaded option. Colour may vary.

Lost or need to replace a camlock seal? Then purchase this 5 pack, so you can have some back ups up your sleeve! 

Material: Silicone 

A tri-clamp cap with a 1/2" female NPT thread. Used to convert a male thread to a tri-clamp connection.

Tri-Clamp Size: 1.5" (3.81cm)
Made from: 304 Stainless Steel

From: Ss Brewtech

A stainless steel Tri-Clamp Cap with 3/8" Barb fitting.

Tri-Clamp (also called Tri Clover) fittings consist of 3 parts: the clamp, the end piece and a silicone gasket. Used in most commercial breweries they are very sturdy. With no nooks or crannies for bacteria/yeast to hide, they clean like a breeze.You can see every surface that meets your precious wort. If that weren't reason enough: they don't leak.

SS O-Ring replacements for Brew Buckets and Mini Brew Buckets.

For use on Brew Bucket 3/8" Ball Valve. Includes:
- 4 pcs 8.5 mm x 1 mm Buna N 70 O-rings
- 2 pcs 16mm x 1.8 mm Buna N 90 O-rings
- 6 pcs total in this set (enough to replace all o-rings on one Brew Bucket valve)

From: Ss Brewing Technologies, USA