Equipment
-
$5.00Duotight Push Fit Tee connector 8mm
This push-fit T-Connector will split the gas (or beer) line on your kegging system in two, allowing you to gas two kegs at the same time. Simple to use and requires no tools. -
$9.00Tail Piece with 1/4" MFL Connector
Tail piece for your dispensing system that provides a 1/4" MFL connector instead of a barb.
From: Krome Dispense
Material: 304 grade stainless steel
Looking for the full setup? Designed to be used with a 5/8" hex nut and a 5/8" neoprene washer. These items sold separately. -
$5.00Duotight - 8mm Push-Fit Check Valve
Duotight 8mm (5/16) one way check valve/non-return valve.
From: Kegland -
$5.00Duotight - 8mm Ball Valve
Duotight - 8mm shut off ball valve. This is an equal ball valve to take 8mm OD tubing in both sides.
No clamps necessary!
From: Kegland -
$4.95Duotight Push In For MFL Connector - 8mm
Easily connect your beer or gas line to your MFL fitting.
Note: MFL keg connector and tubing sold separately.Brand: Duotight
-
$2.95 -
$6.95Stainless barbed tee piece - 1/4"
A barbed stainless steel T (tee) piece for splitting a keg line.
Bore size:
6.35mm (1/4")Out of Stock -
$4.95Duotight - 8mm Push Fit to 5/8"
Duotight push in fitting for 8mm line to 5/8" thread - ideal for keg couplers and tap shanks.
-
$9.00 -
$4.95Duotight - 9.5mm (3/8”) Female x 9.5mm (3/8”) Female Bulkhead with 20mm Locknut
These high quality acetal fittings are made with EPDM o-rings that are reliable, will not perish like cheaper rubber. The acetal plastic is also chemical and UV resistant so it will last for a long time even in testing conditions.
This product is ideally suited to the 9.5mm (3/8") EVABarrier tubing.
