A 5/8" Stainless Ball Valve (Female x Male) for keg couplers or shanks.

This ball valve is incredibly handy for those wanting to control the shut off flow of liquid and gas lines on keg couplers or shanks that have a 5/8" thread. Highly recommended if you are disconnecting your coupler and not re-attaching to another keg immediately.

A Ball Valve that's quick to take apart and clean, and comes with tri-clamp flanges.

- 304 Ss construction - Quick clean type ball valve
- 1.5" TC flanges both ends
- 1" Bore
- Super easy to disassemble and clean

Tri-Clamp Cap that allows you to connect with swivel nuts and other MFL fittlings.

• 1.5" tri-clamp to 1/4" Male Threaded Flare Fitting
• 304 Stainless Construction
• Keg Directly from a Brite Tank
• Serve Directly from a Brite Tank

This bulkhead allows you to add a 1.5" tri-clamp flange to virtually any vessel.

• Weldless design
• Ideal for FTSs and Brew Bucket flat lid pressurised transfers
• Use with Pressurised Transfer Fitting 
• 304 Stainless Construction
• High heat compatible silicone O-ring

These hole punches are great for making really clean holes that are free of burrs. The holes made with this type of punch are significantly better than a hole made with a carbide drill bit or many other hole saws. These produce clean holes and can be used in mild sheet steel up to 3mm thick or stainless steel up to about 1.5mm thick. If you are looking for a really easy way to make really clean holes this is the best product for the job.

Available for a 22mm or 32mm hole.

Tri-Clamp Cap With 17mm Blow-Off Hole and Pressure Relief Valve

Note: Do not buy if you purchased a Brewmaster Edition Chronical fermenter as it comes standard.

- Size: 7.62cm (3")
- Material: 304 Stainless Steel
- Includes custom fabricated 1/2" stainless hose barb
- 17mm hole for 1/2" tubing
- Pressure relief valve included - 3" TC gasket not included

From: Ss Brewtech

Good for hex nipples, and putting pressure on seals.