This pump is constructed of food-grade materials and handles boiling wort with ease. The impeller housing is made from polysulfone as it is a tough, food-grade plastic rated up to 120C. The magnetic drive acts as a clutch allowing the user to put back pressure on the pump to slow down flow without any damage to the pump. Since it is magnetic drive, it’s not self priming, you must put the pump under the level of the liquid source.

A reusable hop straining bag made from nylon mesh. Good for steeping hops or dry hopping, or for adding other things like oak chips to your brew. It's also easy to clean and sanitise.

Size: approx 125mm x 220mm
From: Krome Dispense

D-Type Keg Coupler - Full 304 Stainless - with Duotight 5/8" to 8mm push fit fittings.

Includes:
1 x - D-Type Coupler with 5/8" Male Beer and Gas threads
2 x - duotight 5/8" duotight to 8mm push in
1 x - Non-Return Ball or Torpedo check piece (Non-Return Liquid)
1 x - Gas Duck Bill valve (Non-Return Gas)

'D and S' Type coupler O-ring (Body O-ring) No.5

Normally purchased in increments of x 2. (body takes 2 o-rings)

Gas shut off probe (Keg Coupler Probe seal o-ring No.4)

Compatible with micromatic and all 'D and S' type keg couplers.

Dimensions 17MM OD X 10MM ID

SIlicone check Valve for D&S couplers.
For the larger type check valve see here

Torpedo for standard D&S Type Couplers.

Not compatible with Kegland D-Type Stainless (with Duotight Fittings)