Worn down your washers and seals from filling oodles of sodastream bottles? Then you may want to purchase some extra washers and o-rings

DIY Tap Handle Inserts - Dual Threaded - 3/8″-16 threads, .625″ Length.

Want to make your own unique tap handles but the thread type is strange? These simplistic brass inserts are the answer.

All you'll need is a 12.7mm (1/2") hole drilled into your handle (Pine, Red Gum, Oak, Cherry, Maple, etc), then screw in with a large flat screw driver.

It is important not to push down too hard if you're going to using a screw driver, or wide drill bit. It will strip the thread. Let the piece cut into the wood. Ensure that it is straight.

Suits NukaTap and Intertap taps

These can be used with any kegerator as they are compatible with gas bottles with a standard thread. To use it with the new kegerators, you just need to remove the hose barb.

Type 30 - MK5 CO2 Regulator - Tool-Free - Dual Gauge (4.5bar PRV & 65psi Gauge)

The MK5 Dual Gauge Regulator by KegLand now comes in a tool-free design with a heap of new features.

A gas distributor for splitting your CO2 gas line into multiple outlets, with MFL connections. Options for two, three, and four outlets.

Connect just one cylinder to this gas distributor inlet and dispense from many beer kegs – all at the same time. You get the same pressure at all outlet points.

Stainless Steel 304 Wall Mounting Brackets and Screws Included.

Traditional analogue gauges require a small capillary mechanism where a small pipe expands and unravels under pressure. This in turn drives a mechanical cog to rotate the gauge needle.  This age old technique works quite well especially in large gauges but as this mechanism is manufactured smaller and smaller a tradeoff between accuracy and size becomes the issue.  With very small gauges such as a 27mm x 27mm Mini Gauge it's difficult to make them better than 10% accuracy due to the physical constraints of the mechanical components.

74g CO2 Cartridge | The Big Bulb | (5/8-18UNF Thread).

This CO2 Cartridge has a much larger thread than the standard 16g bulbs. It will require a different bushing if you are to use it with the 360 Core Mini Regulator. It does not suit other regulators in the KegLand range.

This is a fantastic way to make a CO2/Nitrogen gas board so you can control, monitor and display the different pressures to a multi-keg draft system.

These food grade, polypropylene regulator gas boards allow you to mount your mini inline regulators to your wall so you can supply gas to various kegs at different pressures. The mounting holes for the wall mounting are pre-drilled, the holes for the regulators are pre-drilled and this makes installation really easy.