Beer Making
-
$12.95Decal holder 82mm chrome plated plastic
Jazz up your Kegerator or commercial beverage dispensary with these stylish decal holders.
-
$12.95 -
$78.00Ss CIP Spray Ball Tri-Clamp Attachment 1.5"
CIP Spray Ball Tri-Clamp Attachment
- Made from 304 Stainless Steel
- 1.5" tri-clamp cap with 1/2" MPT
- 2 bar / 29 psi recommended
- Use on any 1.5" tri-clamp fittingOut of Stock -
$1.00Neoprene washer for 5/8" hex nut and barbtails
Ensures there are no leaks when using a 5/8" hex nut and an angle or straight barbtail.
The purpose of Neoprene washers is to create a tight fitting seal. The flexibility of rubber means that the bearing surface can be compressed for a tight fit. The neoprene also provides effective protection against corrosion. -
$60.00Dual Tap Font Tower 304 Stainless Steel
Nothing is quite like the quality and robustness of stainless steel. These 304 grade brushed stainless steel fonts are corrosion resistant and look great.
These quality made fonts are also well insulated with a closed cell insulation foam fits the inside of the font snugly preventing unwanted heat ingress into your precious amber beverage. These fonts also will not corrode like the other cheaper chrome plated steel fonts that are common in NZ/Australia.
Specifications:
- 340mm Tall (without taps)
- 78mm Diameter
- Base Collar Diameter 111mm
- Internal Foam InsulationNote: does not include taps
-
$2.50S Airlock - for Fermenter (no cap)
Simple set up, just fill with pre-boiled water, or sanitiser mixture, and insert into your pre drilled hole/bung on your fermenter.
The airlock creates a closed fermentation from inward contaminents. It will allow CO2 to blow off but not let any O2 or bugs into your fermenter.
-
$24.95Tri-Clamp Cap to Ball Lock Post
Tri-Clamp Cap to Ball Lock Post fitting, with both liquid and gas post options. These 1.5" tri-clamp fittings provide a sanitary and leak-proof connection, and can be used with our ball lock connectors. The price is per single unit - gas or liquid - not for pair like in the photos.
-
$2.50 -
$2.50Universal Coupling Gasket for beer faucet No.6
Replacement seal for beer Faucet
Universal Coupling Gasket (back tap seal 20mm)
Number 6 seal in picture - Joins shank to tap.
-
$129.95RIMS Heat Stick Heat exchanger housing
A stainless heat stick housing to help make a RIMS recirculating mash system.
They have been made with TIG welded 50mm stainless pipe with 2 x ½” BSP female sockets at right angles in the top and bottom for the wort to flow in and out.
On each end there is a tri-clamp end cap, one with a 32m hole pre-drilled so it is ready to mount one of our 2200watt elements. The other end cap has a 20mm hole so it is ready to mount either a thermowell or bulkhead. This makes it easy to then use our temperature controller and pump to build your own re-circulating RIMS system.
