These hole punches are great for making really clean holes that are free of burrs. The holes made with this type of punch are significantly better than a hole made with a carbide drill bit or many other hole saws. These produce clean holes and can be used in mild sheet steel up to 3mm thick or stainless steel up to about 1.5mm thick. If you are looking for a really easy way to make really clean holes this is the best product for the job.

Available for a 22mm or 32mm hole.

Tri-Clamp Cap - 3" to 1.5" Reducer. Great for allow you to use existing 1.5" tri-clamp fittings on a 3" TC fermenter.

Note: 3" gasket not included.

Replacement silicone Tri-Clamp Gasket, suitable for all standard tri-clamp fittings. These are all beaded to fit the tri-clamp groove unless specified otherwise.

Currently available in these sizes:

• 3.81cm (1.5")
• 5.08cm (2") (flat, not beaded)
• 5.08cm (2") - (also used as Grainfather conical plug seal)
• 7.62cm (3")
• 10.16cm (4")
• 15.24cm (6")
•  20.32 (8")

Note: photo shows 7.62cm (3") beaded option. Colour may vary.

A 1.5" tri-clamp cap to male camlock adapter.

A stainless steel plate to close, or blank off an outlet. Sometimes it is referred to as a blind cap.

Currently available in these sizes:
- 1.5" (3.81cm)
- 2" (5.08cm)
- 3" (7.62cm)

A 22mm Hole Plug with o-rings and attachment nut, used to plug thermometer, ball valve, and kettle top recirculation holes on Ss Brewtech kettles.

4 Inch to 1.5 Inch Tri-Clamp Reducer.

This is a 1.5 and 4 inch tri-clamp that will fit most standard 1.5 inch and 4 inch tri-clamp hardware.

The tri-clamp system has been a common connection type in the food processing industry and medical industry as its easy to clean, sanitary and no threads are exposed to the product contained in the fittings.