Beer Making
-
$50.00 -
$9.00Quick Disconnect - Male to 1/2" Male
Quick Disconnect - Male to 1/2" Male Fitting. Fits our Female Quick Disconnect. -
$8.10 -
$6.101/2" Inch BSP 316 stainless hex Back Nut
Used in conjunction with a hex nipple, washer and ball valve assembly.Out of Stock -
$2.50 -
$4.00Teflon Thread Seal Tape
Teflon PTFE Thread Seal Tape for sealing threaded joints.
Size: 12mm wide x 10m
Colour: Yellow
Nobody likes leaky fittings in the brewhouse - a little bit of teflon thread tape can make all the difference. -
$19.951.5” Tri-Clamp cap with 3/8" barb
A stainless steel Tri-Clamp Cap with 3/8" Barb fitting.
Tri-Clamp (also called Tri Clover) fittings consist of 3 parts: the clamp, the end piece and a silicone gasket. Used in most commercial breweries they are very sturdy. With no nooks or crannies for bacteria/yeast to hide, they clean like a breeze.You can see every surface that meets your precious wort. If that weren't reason enough: they don't leak.Out of Stock -
$20.00Tri-Clamp Cap with 1/2" Female NPT
A tri-clamp cap with a 1/2" female NPT thread. Used to convert a male thread to a tri-clamp connection.
Tri-Clamp Size: 1.5" (3.81cm)
Made from: 304 Stainless SteelFrom: Ss Brewtech
-
$5.00Camlock Replacement Silicone Seal (5 Pack)
Lost or need to replace a camlock seal? Then purchase this 5 pack, so you can have some back ups up your sleeve!
Material: Silicone
-
$40.00Tri-Clamp Cap With 17mm Blow-Off Hole and PRV
Tri-Clamp Cap With 17mm Blow-Off Hole and Pressure Relief Valve
Note: Do not buy if you purchased a Brewmaster Edition Chronical fermenter as it comes standard.
- Size: 7.62cm (3")
- Material: 304 Stainless Steel
- Includes custom fabricated 1/2" stainless hose barb
- 17mm hole for 1/2" tubing
- Pressure relief valve included - 3" TC gasket not includedFrom: Ss Brewtech
