Pressure Relief Valve (PRV) fitting for connecting onto a gas post so that you can release pressure while controlling the fill speed when transferring beer from one vessel to another.

No clamps necessary, however we do recommend cutting your hosing straight, not on an angle, to ensure the line has a complete seal. To remove the fitting simply push in the collect and the hose can be removed.

These push in fittings are suitable to be used up to 100 psi.

No clamps Necessary!

John Guest 1/4" to 5/16" straight reducer

The Chillout MKIII is the fastest way to chill your wort to yeast pitching temperature to get your fermentation off to a quick healthy start.

The Chillout is made from stainless steel and brazed together with pure copper. It also has ripples up and down each plate. This creates more surface area and improves heat transfer.

Copper Immersion Wort Chiller – 7.5m length

Immersion chillers are the easiest to use and clean chillers for all grain brewers. Just drop it into your hot wort and turn on the water. Occasional stirring or recirculating with a pump will reduce cooling times considerably.

Outer diameter of the copper tube is 10mm. The total diameter of the coil is approximately 250mm.

Stainless Steel Immersion Wort Chiller – 7.5m length

Immersion chillers are the easiest to use and clean chillers for all grain brewers. Just drop it into your hot wort and turn on the water. Occasional stirring or recirculating with a pump will reduce cooling times considerably.

Outer diameter of the stainless steel tube is 10mm. The total diameter of the coil is approximately 250mm.

Replacement air filter for the Grainfather GC2 Glycol Chiller. Not compatible with the GC4 Glycol Chiller.

Stainless steel Immersion Chiller for any 40- 50L Brewing System.

Dimensions 370MM W X 230MM H X 380MM arm height.

Coil diameter - 9.5mm OD