Equipment
-
$42.002″ tri-clamp Bulkhead assembly
A tri clover fitting that will allow you to connect 2″ tri clover fittings to different vessels and systems. Includes a locknut & o-ring to secure the fitting.
-
$16.95 -
$3.45Tri-Clamp Gasket
Replacement silicone Tri-Clamp Gasket, suitable for all standard tri-clamp fittings. These are all beaded to fit the tri-clamp groove unless specified otherwise.
Currently available in these sizes:
- 3.81cm (1.5")
- 5.08cm (2") (flat, not beaded)
- 5.08cm (2") - (also used as Grainfather conical plug seal)
- 7.62cm (3")
- 10.16cm (4")
- 15.24cm (6")
- 20.32 (8")
Note: photo shows 7.62cm (3") beaded option. Colour may vary.
-
$39.95Tri-Clamp Cap - 3" to 1.5" Reducer
Tri-Clamp Cap - 3" to 1.5" Reducer. Great for allow you to use existing 1.5" tri-clamp fittings on a 3" TC fermenter.
Note: 3" gasket not included.
Out of Stock -
$8.10 -
$6.101/2" Inch BSP 316 stainless hex Back Nut
Used in conjunction with a hex nipple, washer and ball valve assembly.Out of Stock -
$2.50 -
$4.00Teflon Thread Seal Tape
Teflon PTFE Thread Seal Tape for sealing threaded joints.
Size: 12mm wide x 10m
Colour: Yellow
Nobody likes leaky fittings in the brewhouse - a little bit of teflon thread tape can make all the difference. -
$19.951.5” Tri-Clamp cap with 3/8" barb
A stainless steel Tri-Clamp Cap with 3/8" Barb fitting.
Tri-Clamp (also called Tri Clover) fittings consist of 3 parts: the clamp, the end piece and a silicone gasket. Used in most commercial breweries they are very sturdy. With no nooks or crannies for bacteria/yeast to hide, they clean like a breeze.You can see every surface that meets your precious wort. If that weren't reason enough: they don't leak.Out of Stock -
$20.00Tri-Clamp Cap with 1/2" Female NPT
A tri-clamp cap with a 1/2" female NPT thread. Used to convert a male thread to a tri-clamp connection.
Tri-Clamp Size: 1.5" (3.81cm)
Made from: 304 Stainless SteelFrom: Ss Brewtech
