The MFL Tap Shank Adaptor is what you need to connect your draft tap directly to your MFL disconnect. These allow you to make a very compact portable setup.

We recommend using one of the Flow Control Nukatap with this adaptor as this provides some restriction of the flow but they will also work with Intertap, Nukatap and other brands of taps. A nylon washer is also recommended between the disconnect and the shank adaptor.

Please bear in mind that due to the compact size there is not enough space to accommodate an auto spring return so it is not compatible that setup.

CIP Spray Ball Tri-Clamp Attachment

- Made from 304 Stainless Steel
- 3" tri-clamp cap with 1/2" MPT
- 2 bar / 29 psi recommended 
- Use on any 3" tri-clamp fitting

Food grade Propylene Glycol (99%) from Kegland in a handy 5 litre container.

This push in gauge is ideal to read pressures during pressurised fermentation. The triple scale gauge gives readings in Bar, PSI and kPA so irrespective of what units you prefer this gauge will display what you need.

The barb on this gauge will enable you to put this directly onto hosing or alternatively you can connect it to any of the push in fittings such as the Duotight push in fittings in the 8mm size.

Specifications:
- 0-40psi / 0-250kPa / 0-2.5 Bar (kg/cm^2)
- Rubber Coated
- 8mm Push in Barb

From: Kegland

For use on the Red handle "Super Automatica Capper" with Tirage Bells. The standard bell supplied with the Super Automatica Capper is 26mm. This larger 31mm bell is compatible with slightly larger caps and bottle tops.

IMPORTANT: This bell is NOT compatible with the "Green Standard Bench Capper"  OR "Lever Bench Capper" - due to different thread size.