A rectangular, counter-top drip tray made of stainless steel with removable cover (no drain).

Includes a cut-out to fit around a beer tower.

Note: design may vary slightly from photo shown.

Dimensions: approx. 30cm x 18cm.

From: Krome Dispense

EVERYONE SHOULD HAVE ONE!

This handy and inexpensive tool is what every home brew kegger should have in the toolbox.  It's really useful for all the most common fittings that you are likely to see in the draft beer world.

This new 7 in 1 tool is also suitable for duotight fittings so it's been improved since the older 5 in 1 tools.

207 Aluminium Cans
This is a box of 207 silver cans with lids, packed in a cardboard box. The Cannular Canning Machine is set up to use these cans out-of-the-box. These have been packed in sanitary conditions however due to the nature of the product we would recommend that you sanitise before use. 

Large Opening
This can design has the "big gulp" opening design that makes the cans easier to drink out of.

This chuck is the chuck that is sold as a separate part so that the Cannular Bench Top Canning Machine can be used with Visy/CDLE ends.  No need to change over the rolls just switch over the chuck, make some fine adjustments to the rolls and table height and you can be seaming CDLE ends in no time at all. 

Fill any beverage into any bottle, can, jar or glass automatically with this internet connected, RAPT enabled, Cannular Can and Bottle Filler. More sanitary and easier to use than other competitors.

This Cannular Can and Bottle filler is ideally used for bottle, cans or even glasses.  Using two adjustable stainless steel tubes it will use one to purge oxygen out of the vessel and then use the second one to fill the vessel to a precise level based on an internal pressure sensor. 

Want to seam 330ml cans?  This is the part you need to lift the table of your Cannular Canning Machine by 50mm so you can do these smaller can sizes.

This add on table spacer has been designed to work with the manual Cannular Can Seamer. The Cannular machines have been designed to work with the 500ml cans right out of the box, however for smaller cans such as the 330ml cans this type of spacer is required to lift the can up a bit higher.

Note: the table spacer is not required for the Semi-Auto Cannular Canning Machine.

The Cannular can seamer is a manual can seamer that is easy to use, reliable and beautifully simple and with this Semi-Auto Model it just got even easier. Now you don't even have to pull a lever to seam the can. The seaming process takes only 3 Seconds!