Equipment
-
$26.95Oxygen Flow Meter
An Oxygen Flow Meter with Duotight 8mm fittings - 0.1-1.5L/min.
This flow control device is designed to be used with an oxygen cylinder and regulator that can be purchased separately. -
$40.00Oxygen/Aeration Wand
An Oxygenation/Aeration Wand is an easy to use tool for adding oxygen to your wort to help ensure healthy yeast growth.
The wand kit includes the 60cm stainless steel 8mm OD wand and the 2 micron aeration stone screws into the end using an MFL thread so it can easily be removed for autoclave or dipped in acid solution. The kit also includes a stainless clamp and 2 meters of vinyl tubing.
Note: You will also need an oxygen cylinder and regulator which are not included.
Stone: 2 micron
Wand Length: approx. 650mm total
From: KeglandOut of Stock -
$14.95Diffusion Stone - 0.5 Micron (barbed)
A carbonation or aeration diffusion stone. This can be used as a way to aerate your wort prior to fermentation, or to speed up carbonation of the finished beer.
The barb fits 1/4" (6.35mm) ID tubing.
Out of Stock -
$14.95Stainless steel 2 Micron Diffusion Air Stone (barbed)
Use this 2 micron stone with an oxygen source or an aeration pump to provide your yeast with oxygen pre-fermentation, or with CO2 to speed up carbonation of the finished beer.
The barb fits 1/4" (6.35mm) ID tubing.
From: Keg KingOut of Stock -
$13.95SIlicone check Valve for D&S coupler
SIlicone check Valve for D&S couplers.
For the larger type check valve see here -
$5.00 -
$8.80 -
$9.45Silicone Check Valve for A Type Coupler
Silicone Check Valve for A Type CoupleraSilicone Check Valve for A Type Coupler.
For the smaller type check valve see here -
$79.95Keg Coupler - D Type Stainless with PRV
Keg Coupler - D Type (US Sankey) - with pressure relief valve and stainless steel body.
-
$0.501/4 Nylon Flare Washer Olive For MFL Fittings
Prevent gas or liquid leaks on your MFL connections This washer fits inside any of our MFL conections which are on our MKIII multi gas regulators, MFL ball and pin lock disconnects, cold plate, FFL swivel nut and barb and FFL 8mm push fitting..
