This push in joiner is suitable for our EVABarrier Beer & Gas hosing in 9.5mm (3/8") OD line.

No clamps necessary!

This Elbow Piece is suitable for EVABarrier Beer & Gas hosing in 4mm ID & 5mm ID line or most lines with 8mm outer diameter. 

No clamps necessary!

Duotight 9.5mm x Ball Lock Disconnect (Black + Yellow/Liquid)

This all new ball lock disconnect sets a new bar! The integrated Duotight design means you can connect your beer and gas line directly, easily and reliably - no need for additional fittings or clamps.

Duotight 6.35mm x Ball Lock Disconnect (Black + Yellow/Liquid)

This all new ball lock disconnect sets a new bar! The integrated Duotight design means you can connect your beer and gas line directly, easily and reliably - no need for additional fittings or clamps. 

6mm hose barb X 1/8 bsp thread (brass)

This fitting is compatible with Mangrove Jack's mini regulator allowing a gas line to feed from the regulator to the keg. (no direct keg mount)
Works with the Portable Dispencing kit also.
Note you need thread tape for the above application.

This easy to use and compact spunding valve is handy for keg transfers or pressurized fermentations when you want to limit oxygen exposure and use counter pressure in the keg you are filling into or in the fermenter you are using.

Seal Kit - duotight 8mm x Flow Control Ball Lock Disconnect

Please refer to the product photos for an exploded diagram of where the replacement seals and poppet placement. 

Serve your beer to multiple places from a single source with this clever liquid manifold.

Connect the keg to the manifold barb end and dispense to three locations.

• 3-way, one barb end manifold – lets you serve at three locations
• Made of 304 grade stainless steel
• Wall mount bracket included

Duotight 8mm x Flow Control Ball Lock Disconnect (Black-Yellow/Liquid).

This all new ball lock disconnect sets a new bar! The integrated duotight design means you can connect your beer line directly, easily and reliably - no need for additional fittings or clamps. It is a robust and super compact compared to the previous Stainless Steel Flow Control Ball Lock that has been discontinued due to the difficulty in repeated tooling and overall cost of raw materials.