Connectors
-
$4.95Duotight 8mm (5/16) Female x 1/4 Inch BSP Male Thread (With Seated O-Ring)
This handy small duotight to male 1/4 BSP threaded piece. Particularly useful for many standard gas fittings. The 1/4 inch thread fits into the regulator body, manifolds and many other fittings that often use 1/4inch thread.
Brand: Duotight
Material: Plastic
-
$7.95Push-fit joiner - 10mm
This Push-Fit Joiner will allow you to join beer or gas line sections on your kegging system.
Note that this is 10mm diameter in and out.
They are extremely easy to use and allow you to simply push your beer and gas line straight into these fittings. No need to purchase clamps or tools.
To remove the fitting, simply push in the collet and the hose can be removed.
Fits 10mm outer diameter tube.
Note: colour may vary.
-
$4.95Duotight Push In For MFL Connector - 8mm
Easily connect your beer or gas line to your MFL fitting.
Note: MFL keg connector and tubing sold separately.Brand: Duotight
-
$5.00Duotight - 8mm Ball Valve
Duotight - 8mm shut off ball valve. This is an equal ball valve to take 8mm OD tubing in both sides.
No clamps necessary!
From: Kegland -
$5.00Duotight - 8mm Push-Fit Check Valve
Duotight 8mm (5/16) one way check valve/non-return valve.
From: Kegland -
$9.00Tail Piece with 1/4" MFL Connector
Tail piece for your dispensing system that provides a 1/4" MFL connector instead of a barb.
From: Krome Dispense
Material: 304 grade stainless steel
Looking for the full setup? Designed to be used with a 5/8" hex nut and a 5/8" neoprene washer. These items sold separately. -
$5.00Duotight Push Fit Tee connector 8mm
This push-fit T-Connector will split the gas (or beer) line on your kegging system in two, allowing you to gas two kegs at the same time. Simple to use and requires no tools. -
$5.00Duotight Push-Fit Elbow 8mm
This Push-Fit Elbow - 8mm x 8mm - will allow you to join beer or gas line sections on your kegging system. Simple to use and requires no tools. -
$5.00Elbow Pipe Joiner 1/4" x 1/4"
Elbow Pipe Joiner for your keg dispensing system. These simple draft beer parts can extend or repair your beer and gas line. -
$5.00Elbow Pipe Joiner 3/16" x 3/16"
Elbow Pipe Joiner for your keg dispensing system. These simple draft beer parts can extend or repair your beer and gas line. Made of stainless steel, they’re designed to maintain the inside diameter of your hose.
