Connections and Valves
-
Camlock – Type D female x 1/2 inch female
Camlock – Type D female x 1/2 inch female
Stainless Steel - 150psi/11Bar Operating Pressure -
Camlock – Type E male x 1/2 inch barb
Camlock – Type E male x 1/2 inch barb
Stainless Steel - 150psi/11Bar Operating Pressure -
Nut – with recess for seated o-ring (1/2 bsp)
1/2 BSP Stainless Steel Nut with a recess for an o-ringOut of Stock -
Tri-clamp 1.5"
Tri-clamp 1.5 inch / 3.81cm. A quality stainless steel tri-clamp with 1.5" being the most common tri-clamp size.
We also stock tri-clamp seals and a range of fittings that are compatible with this diameter of tri-clamp.
Tri-Clamp (also called Tri Clover) fittings consist of 3 parts: the clamp, the end piece and a silicone gasket. Used in most commercial breweries they are very sturdy. With no nooks or crannies for bacteria/yeast to hide, they clean like a breeze.You can see every surface that meets your precious wort. If that weren't reason enough: they don't leak. -
Tri-clamp 3"
Tri-clamp 3 inch
Tri-Clamp (also called Tri Clover) fittings consist of 3 parts: the clamp, the end piece and a silicone gasket. Used in most commercial breweries they are very sturdy. With no nooks or crannies for bacteria/yeast to hide, they clean like a breeze.You can see every surface that meets your precious wort. If that weren't reason enough: they don't leak.Out of Stock -
Tri-clamp Cap 1.5" with 13mm Barb
Tri-clamp Cap with 13mm Barb
Tri-Clamp (also called Tri Clover) fittings consist of 3 parts: the clamp, the end piece and a silicone gasket. Used in most commercial breweries they are very sturdy. With no nooks or crannies for bacteria/yeast to hide, they clean like a breeze.You can see every surface that meets your precious wort. If that weren't reason enough: they don't leak. -
Shut Off Valve - MFL With Return Check Valve
A gas shut off valve with built in return check valve and MFL nipple. -
Tri-Clamp Cap with 1/4" Barb
Stainless steel tri-clamp cap (1.5") to 1/4″ (6.35mm) Hose Barb.
- Made out of 304 Stainless Steel
- 1/4″ OD Hose Barb
- Designed for use with 1/4″ ID tubing
-
Hole Plug - 22mm for Ss Brewtech Kettle
A 22mm Hole Plug with o-rings and attachment nut, used to plug thermometer, ball valve, and kettle top recirculation holes on Ss Brewtech kettles.
Out of Stock