pH Buffer powder 9.18 to use for calibration of pH meters. Designed to be used with R.O water at 25 degrees celcius. Add contents to 250ml of water until dissolved.

pH Buffer powder 6.86 to use for calibration of pH meters. Designed to be used with R.O water at 25 degrees celcius. Add contents to 250ml of water until dissolved.

Reads 0 -100

Contains no mercury

For use with the Euro 5 and MK5E stills

Hydrometer jar - one piece alcohol resistant plastic.

The main tube is approximately 25cm tall, and it has a graded scale from 20ml to 210ml in 2ml increments, as well as a fluid ounce scale from 1 to 7 in 1oz increments. The diameter of the base is approximately 8cm.

This professional ph meter is designed to measure and display both pH levels and temperature with very high accuracy. Featuring IP67 - 100% splashproof & dustproof, selectable °C & °F, large display screen, replaceable electrode, 3-point calibration system and comes with free 3 pH Powder (pH4.00, pH6.86 & pH9.18).

It comes with built-in Automatic Temperature Compensation (ATC), you don't have to worry about the effect of temperature change on pH level.

 

Poly bulkhead for 6.5mm diameter temperature probe

Alcometer with 0-100% and Proof scales, with instructions. It is not recommended for testing beer, wine or liqueurs as it is most reliable when measuring the alcohol content of liquids with a higher percentage alcohol.

Calibrated to 20 degrees C.

Stick-on Thermometer strip graded from 10 degrees C to 40 degrees C. Can be stuck to the outside of any fermenter to give an indication of the temperature of the liquid inside.

We find these are quite reliable but it is always a good idea to test the calibration of any thermometer from time to time. For these stick-on versions, we recommend doing this especially as it gets older or if it is exposed to excessive heat such as hot cleaning water.

Glass trial jar - 100ml. Suitable for hydrometer readings.

Has a graded scale allowing you to measure volumes of liquid from 10ml to 100ml in 1ml increments. The main tube is approximately 21.8cm deep, and it has a lipped edge to assist with pouring liquids out. Diameter of the base is approximately 5.5cm.