DIY Tap Handle Inserts

DIY Tap Handle Inserts - Dual Threaded - 3/8″-16 threads, .625″ Length.

Want to make your own unique tap handles but the thread type is strange? These simplistic brass inserts are the answer.

All you'll need is a 12.7mm (1/2") hole drilled into your handle (Pine, Red Gum, Oak, Cherry, Maple, etc), then screw in with a large flat screw driver.

It is important not to push down too hard if you're going to using a screw driver, or wide drill bit. It will strip the thread. Let the piece cut into the wood. Ensure that it is straight.

Suits NukaTap and Intertap taps

From: Kegland