MTSs Temp Controller for Infusion Mash Tun

MTSs Temp Controller for Infusion Mash Tun

Availability: Out of Stock

This product will be sent direct from our supplier. If they are out of stock we will contact you to discuss if you prefer to wait or receive a full refund.


The MTSs Temperature Controller is designed for use with Ss Brew Tech's Infusion Mash Tun.

During extended Mash periods or in relatively cold ambient temperatures, the mash will naturally drop in temperature. With the MTSs you will be able to provide better controlled temperatures during the mash scarification process. Holding a consistent scarification temperature will insure you are making the beer and flavour profiles you planned to produce.

The MTSs is a low wattage silicone heater pad, which is bonded to the underside of the 5 degree sloped bottom on your Mash Tun using a strong adhesive backing on the heater pad. The heater is controlled with a 12 volt digital temp controller. You simply set your target temperature and the heater will cycle on and off to maintain your set point.

This system is not designed for heating water to strike temp and/or step mashing, though it can help with fine tuning your strike water temp those last few degrees and/or maintaining your strike water temp while you are preparing your grist or balancing your water chemistry.


  • Keep your mash temperature stable
  • Holds mash temp to within 1 degree of set point
  • 12V adhesive heater pad
  • 6A 12V Power supply (bigger than FTSs)
  • Digital temp controller
  • Grommet / zip tie (for strain relief)

Customer Reviews

Review "MTSs Temp Controller for Infusion Mash Tun"

Write Your Own Review