For enthusiasts wanting to make clean pure neutral spirit.

The whole system is designed to save, time, money and parts, and fit in one box for easier storage and cheaper shipping.

With its easy to use operation, amazing features, and rock-solid reliability, the Spirit Maker is the foundation of Pure Distilling. Even as our competitors try to catch up, the technologies and features built into this design keep our homemade alcohol distiller years ahead of the DIY home distilling trend. Whether you’re assembling the whole unit in under a minute, or watching your bottles fill with commercial quality alcohol in your very own home – it is simple, easy and fun to use.

Note: With Robobrew units you will need to purchase the stainless lid with 47mm hole.  This is sold separately and is not included with the Robobrew unit.  The stock glass lid that comes with the Robobrew unit will not be suitable.

The still also fits many standard boilers such as the standard Turbo Boilers, Robobrew, and it also works with the Grainfather and T-500 boiler.

No more stuffing around with water flow speed!

Do you want to distill faster or get higher purity spirit?  Then you should try this stainless extension tube - https://leagueofbrewers.co.nz/2inch-tri-clover-extension-tube.htm

This stainless steel extension tube can be filled with copper or stainless packing.  By increasing the volume of the reflux still column this will enable you to get higher purity and/or collect spirit faster (it's basically a trade off between the two).

Some stills are hard to opperate and require fine tuning of the water flow in the condenser.  These stills include the t500 and other coolent management or (CM) designs.  This means that you have to constantly adjust the flow of water/coolent to get consisten results.  This can be also an issue if you are using a pressure pump that cycles on and off in your house or it can even be an issue if you flush the toilet and momentarily the pressure in your hose feeding the still drops.  This still on the other hand is a FM design which controls the flow of spirit directly.  So as long as you have enough coolent it doesnt matter how fast your coolent flows through the still.  This makes the still far easier to opperate than many other brands like the t500.  The purity of the spirit can be controlled by two included flow control inserts that are show in the attached photos.  These brass inserts come with a 1.0mm hole and a 0.6mm hole.  As the hole gets smaller you the speed of which the spirit comes out of the still will decrease and this will in turn increase your reflux ratio and therefore give you higher purity.  This makes this still design Extremely easy to use as you just open up the ball valve and let the flow control insert of your choice do the job.

Typically the 1.0mm insert is good for stripping runs and then on the final cut you can use the 0.6mm insert.  Alternatively you can use the ball valve to control the spirit flow too but this is a sensitive adjustment and required a bit more skill for this type of manual adjustment so we recommend you just use the brass inserts that come included.

Here's a video on some automation with this still and the temperature controller below.

Can easily be connected to the Still spirits 2" sight glass (not included). To make this happen all you need is a 2" clamp' tri-clamp.